Familia Capella Mazda3 Mazda6 CX-? Others Articles

Mazda6 GG (2002-2008)

Removal and installation the license plate light (Mazda 6 GG)

0

Disconnect the negative cable from the battery.

Remove the rear trim.

Fig. 7.43. Components of the license plate light: 1 – connector; 2 – license plate light; 3 – lens;…

Fig. 7.43. Components of the license plate light: 1 – connector; 2 – license plate light; 3 – lens; 4 – lantern lamp

Remove in the order shown in Figure 7.43.

Original material on the website: MAZBOOK.RU

Install in the reverse order of removal.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This text was checked by: Evdokia Filimonova

Share with friends on social networks:

Previous

Mazda6 GG » Lighting system

Next

Removal and installation an additional brake light
Removal and installation additional brake light on rear spoiler
Removal and installation additional brake light
Removal and installation the interior combination light
Removal and installation the rear combination light

Removal and installation the front interior light
Removal and installation the door limit switch
Removal and installation the ashtray light
Removal and installation the ignition switch illumination lamp
Removal and installation the glove compartment light

More articles on repairing other Mazda models
E-b2. Wiring diagram for side direction indicators, headlights,… Mazda Familia 5 (1985-1989)
Scheme 5: Headlights, side lights, parking lights, rear fog light,… Mazda Capella 3 (1982-1992, petrol)
License plate light bulbs Mazda3 BK (2003-2009)
License plate light, parking lights, signal lights Mazda CX-5KE (2012-2017)
Disassembling and assembling the license plate light Mazda BT-50 (1) (2006-2011)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Mazda6 GG (2002-2008)

By continuing to use the site, you agree to the use of cookies 🔐