Battery, alternator and starter Mazda 6 (GG)

Electrical supply system — general information
The power supply system consists of a generator, a voltage regulator and a battery. When these devices work together, they supply power to such consumers of electricity...

Battery — General Information
Fig. 7.4. Mazda 6 battery: 1 – negative terminal wire; 2 – positive terminal wire; 3 – mounting bracket; 4 – battery; 5 – lower tray The vehicle covered in this manual...

Checking the battery charge level
The density of the electrolyte together with the measurement of the voltage at the terminals of the battery allow you to make an accurate conclusion about the degree of...

Charging the battery
A battery with a green dot indicates that charging is not required until the battery is discharged, such as when starting a cold engine. When charging a battery with...

Charging a completely discharged battery
Use the following procedure to recharge a completely discharged battery. Measure the voltage at the battery terminals with an accurate voltmeter. If the measured value...

Battery care
To ensure that your battery lasts longer and maintains its maximum capacity, the following conditions must be met. The battery and its surrounding parts should be kept...

Checking a fully charged battery
Set the ammeter (with a measurement limit of 0-5 mA and 0-5 A) to the highest measurement limit. Connect the ammeter between the negative terminal of the battery and the...

Removal and installation the battery
When the battery is disconnected, the memory of the central control unit of the engine and gearbox, the anti-lock braking system, and a number of other electrical...

Checking the generator on the car
Check the voltage at the generator terminals. Make sure the battery is fully charged. Make sure the alternator belt deflection and tension are within the specified...

Checking the battery charge indicator
Make sure the battery is fully charged. Make sure the alternator belt deflection and tension are within the specified values. Turn the ignition switch to the "ON"...

Checking the current strength at the generator terminals
Make sure the battery is fully charged. Make sure the alternator belt deflection and tension are within the specified values. Disconnect the cable from the negative...

Removal and installation the generator
Warning! When the battery is connected, a flashover may occur between the vehicle body and the B terminal. This may result in injury, fire, or damage to the vehicle's...

Removal and installation of high-voltage wires
Caution: High-voltage wires must be installed in the same order as they were installed previously, otherwise it may damage the engine electrical equipment. Removing the...

Checking the starter on a car
Make sure the battery is fully charged. Turn the crankshaft with the starter and make sure that the starter operates smoothly, without any extraneous noise. If operation...

Checking the starter without load
Make sure the battery is fully charged. Fig. 7.8. Connection diagram of a voltmeter and ammeter to the starter Connect a voltmeter and ammeter to the starter as shown in...

Removal and installation the starter
Disconnect the cable from the negative battery terminal. Remove the air intake duct. Remove the intake manifold bracket. Fig. 7.9. Removing the starter: 1 – connector B;...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections on repairs of other Mazda models
• Electrical equipment: Power devices Mazda Familia 6 (1989-1994)
• Electrical equipment: Power devices Mazda Capella 3 and 4 (1982-1992)
• Electrical equipment: Power devices Mazda3 BK (2003-2009)
• Electrical equipment: Power devices Mazda 121 (3) (1996-2003)

Share with friends on social networks:

Link in different formats to this section

TEXTHTMLBB Code

Mazda6 GG (2002-2008)