Vehicle lighting system Mazda 6 (GG)

Car exterior lighting system
Fig. 7.10. Exterior lighting system of the Mazda 6: 1 – front combination light; 2 – rear combination light; 3 – internal combination lamp; 4 – Front side direction...

Front combination light
Fig. 7.11. Front combination light: 1 – headlight bulb (low beam); 2 – gas discharge headlight bulb (low beam); 3 – Front direction indicator lamp; 4 – Front fog light...

Design and operation of a gas discharge headlight
High voltage pulse (alternating current with a voltage of approximately 25,000 V) from the gas-discharge headlight control unit is supplied between the terminals of its...

Headlight fault detection function
Input voltage drop detection function If the input voltage of the gas discharge headlight control unit (9-16 V) is less than normal (except for the voltage drop...

Automatic headlight leveling system
Fig. 7.14. Automatic headlight leveling system: 1 – Automatic alignment control unit (main); 2 – Automatic leveling control unit (additional); 3 – Front automatic...

Operation of headlights when vehicle load changes
1. According to the vibration of the suspension, the automatic leveling sensors installed at the front and rear of the vehicle send a signal to the automatic leveling...

Operation of headlights while the vehicle is moving
1. When driving with the headlights on, the automatic leveling control unit (main) receives a vehicle speed signal from the ABS/TCS HU/CM or DSC HU/CM and a suspension...

Driving Lighting Control System
The vehicle's driving lighting control system automatically controls the operation of the low beam headlights and TNS when the ignition is turned off via a special unit....

Rear combination light and inner combination light
A stepped reflector is used to diffuse and reflect the light from the rear combination lamp and interior combination lamp. A flat, uncut lens is used to control the...

Interior lighting system
Fig. 7.19. Interior lighting system: 1 – front navigation lamp (with hatch); 2 – front navigation lamp (without hatch); 3 – rear navigation lamp; 4 – glove compartment...

Removal and installation the front combination headlight
Warning: Improper maintenance of HID headlights may result in electric shock. Note: When the ignition switch is turned to the ON position, the operating sound of the...

Adjusting the low beam headlights
Fig. 7.21. Headlight low beam adjustment diagram Install the headlight adjustment screen as shown in Figure 7.21. Adjust the air pressure in your tires to the correct...

Adjusting the high beam headlights
Adjust the air pressure in your tires to the correct level. Place the unloaded vehicle on a horizontal surface. Place one person in the driver's seat. Position the car...

Removal and installation the headlight bulb
Disconnect the negative cable from the battery. Disconnect the front combination lamp. Fig. 7.26. Headlight component removal procedure: 1 – lid; 2 – connector; 3 –...

Removal and installation a gas discharge lamp headlight
Warning: Improper maintenance of HID headlights may result in electric shock. Disconnect the negative cable from the battery. Disconnect the front combination lamp. Fig....

Removal and installation the high beam lamp
Disconnect the negative cable from the battery. Fig. 7.28. Procedure for removing high beam lamp components: 1 – lid; 2 – connector; 3 – high beam lamp Remove in the...

Removal and installation the parking light bulb
Disconnect the negative cable from the battery. Fig. 7.29. Procedure for removing the parking light bulb components: 1 – lid; 2 – lamp socket; 3 – parking light bulb...

Removal and installation the front turn signal
Disconnect the negative cable from the battery. Fig. 7.30. Procedure for removing the front turn signal lamp components: 1 – lamp socket; 2 – lamp Remove in the order...

Removal and installation the side turn signal
Disconnect the negative cable from the battery. Fig. 7.31. Procedure for removing the side turn signal lamp components: 1 – Front side direction indicator; 2 – connector...

Adjusting the front fog light
Adjust the air pressure in your tires to the correct level. Place the unloaded vehicle on a horizontal surface. Place one person in the driver's seat. Place the car 3m...

Removal and installation the front fog light bulb
Disconnect the negative cable from the battery. Fig. 7.34. Procedure for removing the front fog lamp components: 1 – lid; 2 – connector; 3 – Front fog light bulb Remove...

Removal and installation the rear combination light
Disconnect the negative cable from the battery. Remove the side trunk trim. Fig. 7.35. Components of the rear combination light: 1 – connector; 2 – bolt; 3 – rear...

Removal and installation the interior combination light
Disconnect the negative cable from the battery. Remove the trunk lid trim (lower tailgate trim). Fig. 7.36. Components of the internal combination lamp: 1 – connector; 2...

Removal and installation additional brake light
Disconnect the negative cable from the battery. Fig. 7.39. Components of the additional brake light: 1 – connector; 2 – additional brake signal; 3 – lamp socket; 4 –...

Removal and installation additional brake light on rear spoiler
Disconnect the negative cable from the battery. Remove the rear spoiler. Fig. 7.40. Thread installation diagram Tie a string to the end of the auxiliary brake light...

Removal and installation an additional brake light
Disconnect the negative cable from the battery. Remove the lower trim of the tailgate. Fig. 7.42. Components of the additional light: 1 – connector; 2 – nut; 3 –...

Removal and installation the license plate light
Disconnect the negative cable from the battery. Remove the rear trim. Fig. 7.43. Components of the license plate light: 1 – connector; 2 – license plate light; 3 – lens;...

Removal and installation the front interior light
Disconnect the negative cable from the battery. Fig. 7.44. Components of the front interior light: 1 – front light; 2 – connector; 3 – lamp socket; 4 – lantern lamp...

Removal and installation the door limit switch
Front part Disconnect the negative cable from the battery. Fig. 7.47. Procedure for removing door limit switch components: 1 – screw; 2 – door switch; 3 – connector...

Removal and installation the ashtray light
Disconnect the negative cable from the battery. Remove the cover panel. Fig. 7.50. Procedure for removing the ashtray lighting lamp: 1 – lamp socket; 2 – ashtray...

Removal and installation the ignition switch illumination lamp
Disconnect the negative cable from the battery. Remove the steering column trim. Fig. 7.51. Removing the ignition switch illumination lamp Remove the ignition switch...

Removal and installation the glove compartment light
Disconnect the negative cable from the battery. Fig. 7.52. Procedure for removing the glove compartment light: 1 – lamp socket; 2 – glove compartment illumination lamp...

Removal and installation the instrument panel lighting control switch
Disconnect the negative cable from the battery. Fig. 7.53. Procedure for removing the instrument panel lighting control switch: 1 – control switch for lighting on the...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections on repairs of other Mazda models
• Electrical equipment: Lighting and headlights Mazda Familia 6 (1989-1994)
• Electrical equipment: Lighting and lamps Mazda Capella 3 (1982-1992, petrol)
• Electrical equipment: Lighting system Mazda3 BK (2003-2009)
• Electrical equipment: Lighting system Mazda 121 (3) (1996-2003)

Share with friends on social networks:

Link in different formats to this section

TEXTHTMLBB Code

Mazda6 GG (2002-2008)