Vehicle lighting system Mazda 121 (3)

Lighting System — Ford Fiesta / Mazda 121
The lighting system includes the following components: headlights, fog lights, tail lights, brake lights, turn signals, rear fog lights, rear number plate lights and...

Table of incandescent lamps
The purpose of a 12-volt light bulb Type Power, W Low beam H7 55 High beam H1 55 Fog lights H1 55 Front direction indicators (yellow)* with a bayonet base 21 Front...

Replacing incandescent light bulbs
Turn off the corresponding lighting fixture using the switch. Headlights Remove the headlight. Pull off the low beam lamp plug (3). Press the wire clip (4) upwards and...

Removal and installation the headlight
Removal Pull up the radiator grille and remove it. Unscrew the three screws securing the container. Caution: The Torx head bolt on the headlight housing must not be...

Removal and installation headlight glass
Removal Remove the headlight. Use a screwdriver to pry up the six headlight glass clips. Remove the glass (diffuser). Remove the sealing rubber from the headlight...

Headlight adjustment
Correct headlight adjustment is of great importance for driving safety. Precise adjustment of headlights is only possible with the help of a special adjustment device....

Removal and installation the rear light
Removal Remove the side trim in the trunk. Remove the plug from the lamp mount. Unscrew the three nuts and remove the rear light. Installation Place a new rubber seal on...

Ford KA: Replacing Headlight Bulbs
Please note: Ford KA models are equipped with H1 bulbs with a UV filter, which can be identified by the letter "i" on the bulb base. H7 lamps must have a UV filter. Turn...

Ford KA: Headlight Removal and Installation
Please note: The Ford KA model has a lens lens that is glued to the headlight and cannot be replaced separately. Removal Remove the front bumper. Unscrew the four...

Ford KA: Headlight Adjustment
The adjustment process is the same as for the models Ford Fiesta/Mazda 121 . Position of the adjusting screws: 1 - height adjustment screw; 2 - screw for lateral...

Ford KA: Removing and installing the taillight
Removal Remove the plug from the lamp mount. Unscrew the three nuts and remove the taillight. Installation Place the sealing rubber on the rear light. Insert the tail...

Removal and installation the radio
The factory installed radio is equipped with a special mount that allows for quick removal and installation of the radio. In other cases, the radio comes with two...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections on repairs of other Mazda models

• Electrical equipment: Lighting and headlights Mazda Familia 6 (1989-1994)
• Electrical equipment: Lighting and lamps Mazda Capella 3 (1982-1992, petrol)
• Electrical equipment: Lighting system Mazda3 BK (2003-2009)
• Electrical equipment: Lighting system Mazda6 GG (2002-2008)

Share with friends on social networks:

Link in different formats to this section

TEXTHTMLBB Code