Vehicle all-wheel drive system Mazda BT-50 1

Diagnostics of the all-wheel drive system
Reading and erasing fault codes Reading and erasing fault codes is only possible with the diagnostic tool. For detailed information on the procedures for reading and...

All-wheel drive system — device
Location of all-wheel drive system components. 1 - all-wheel drive engagement sensor, 2 - transfer case neutral gear engagement sensor, 3 - front axle disconnect sensor,...

Checking the all-wheel drive engagement sensor
1. Jack up the car and place it on stands. 2. Remove the all-wheel drive engagement sensor. 3. Make sure there is conductivity between the sensor terminals when the...

Checking the transfer case neutral gear engagement sensor
1. Jack up the car and place it on stands. 2. Remove the all-wheel drive engagement sensor. 3. Make sure there is conductivity between the sensor terminals when the...

Checking the front axle disconnect sensor
1. Jack up the car and place it on stands. 2. Remove the front axle disconnect sensor. 3. Make sure there is conductivity between the sensor terminals when the sensor...

Front axle switch
Removal and installation Note: Installation is carried out in the reverse order of removal. 1. Remove the lower trim on the driver's side. 2. Press the latches to remove...

Checking the one-way valve
1. Remove the one-way valve. 2. Apply compressed air to the "A" side of the hose and make sure that air comes out of the "B" side. 3. Apply compressed air from side "B"...

Checking the electromagnetic valves for connecting and disconnecting the front axle
1. Disconnect the hoses and connectors from the solenoid valves. 2. Apply compressed air to port "B" and make sure that air comes out through the filter. 3. Connect the...

Checking the front axle disconnect drive
1. Jack up the car and place it on stands. 2. Disconnect the vacuum hoses from the drive. 3. Connect the hand vacuum pump to the drive (front axle disconnect circuit),...

Intermediate Drive Shaft Assembly — Removal and Installation
1. Drain the oil from the front gearbox (see chapter " Maintenance and general check and adjustment procedures "). 2. Remove the parts in the order they are numbered in...

Intermediate Drive Shaft Assembly — Disassembly and Assembly
Removal and installation of parts is carried out using the assembly drawing "Intermediate drive shaft assembly". Intermediate drive shaft assembly. 1 - body, 2 - oil...

Front Axle Disconnection Mechanism — Removal and Installation
1. Drain the oil from the front gearbox (see chapter " Maintenance and general check and adjustment procedures "). 2. Remove the parts in the order they are numbered in...

Front Axle Disconnection Mechanism — Disassembly and Assembly
Remove the parts in the order they are numbered in the assembly drawing "Front Axle Disengagement Mechanism". Front axle disconnect mechanism. 1 - retaining ring, 2 -...

Drive shafts — disassembly and assembly
1. Remove the parts, referring to the "Drive shaft" figure. Drive shaft. 1 - clamp, 2 - thrust ring, 3 - outer race of the inner joint, 4 - retaining ring, 5 - balls, 6...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share with friends on social networks:

Link in different formats to this section

TEXTHTMLBB Code