Clutch — device Location of clutch components. 1 - working fluid tube, 2 - brake fluid reservoir, 3 - clutch pedal, 4 - master cylinder of the clutch release drive, 5 - clutch slave...
Checking the clutch fluid level The procedure for checking the fluid level is described in chapter " Maintenance and general inspection and adjustment procedures ".
Pumping the clutch hydraulic drive Note: When bleeding the clutch fluid, keep the fluid level at 3/4 reservoir or more. Recommended Fluid Type - SAE J1703, FMVSS 116 DOT-3 1. Remove the cap from the...
Clutch pedal Check and adjustment 1. Check the clutch pedal travel. Depress the clutch pedal and measure the pedal travel. Pedal travel - 152 mm Adjust pedal travel if necessary....
Clutch Master Cylinder Removal and installation Caution: Do not allow clutch fluid to come into contact with painted surfaces. If this happens, wash off the spill immediately. 1. Remove the...
Clutch slave cylinder Removal and installation Attention: during work, do not allow it to come into contact with painted surfaces. If this happens, wash off the spill immediately. 1. Remove...
Coupling — removal and installation 1. Remove the parts in the order they are numbered on the assembly drawing "Removal and installation of clutch". 2. Install in the reverse order of removal. Withdrawal...
Clutch — check 1. Check the clutch cover. A) Using a vernier caliper, measure the depth of the diaphragm spring wear groove. Maximum allowable wear in depth "A" - 0.6 mm b) Using a...