Note: When bleeding the clutch hydraulic system, maintain the working fluid level at about 3/4 of the reservoir or more.
- Recommended type of working fluid - SAE J1703, FMVSS 116 DOT-3
1. Remove the cap from the bleed nipple and connect the vinyl hose to the bleed nipple.
2. Place the other end of the hose in a special container to collect the working fluid.
3. Ask an assistant to press the clutch pedal three or four times and hold the pedal depressed.
4. With the clutch pedal depressed, loosen the bleed screw and allow the working fluid to drain.
5. Tighten the bleed screw.
- Tightening torque: 6-9 Nm
6. Repeat procedures 3-5 until air bubbles stop appearing in the outgoing liquid.
7. After pumping, perform the following checks:
Content based on information from MAZBOOK.ru
- make sure the clutch is working properly;
- check the system for leaks;
- check the working fluid level in the tank.
Add new working fluid up to the "MAX" mark.