Gasoline engine 1.25/1.4L car Mazda 121 (3)

Removal the timing belt
A. Direction of movement; 1. Ignition coil; 2. Coolant outlet; 3. Coolant temperature sensor; 4. Flywheel; 5. Throttle body; 6. Oil pressure warning light switch; 7. Oil...

Setting the engine to the TDC position of the first cylinder
Turn the engine so that you can insert a ruler into the grooves on the end face of the camshafts. There are several ways to turn the engine (crankshaft). 1. Support the...

Installing a timing belt
Place the toothed belt on the sprockets. Install the engine mount bracket onto the cylinder block and tighten the bolts to 55 Nm. Secure the right engine mount with new...

Removal and installation camshafts
Note: If the timing parts are to be reused, they must be installed in the same positions. To avoid confusion, it is recommended to make a special storage box. Removal...

Removal and installation the cylinder head
Note: Operations and instructions applicable to all engines are given in the section dedicated to the 1.3L engine. This section describes only the differences. Removal...

Removal, installation and tensioning the poly V-belt
Disconnect the negative cable from the battery with the ignition off. Note: This will erase data from electronic memory blocks, such as radio codes. See instructions in...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections on repairs of other Mazda models
• Power unit: Petrol engines Mazda Familia 6 (1989-1994)
• Power unit: Gasoline engine Mazda Capella 3 and 4 (1982-1992)
• Power unit: Petrol engines 2.5 l Mazda CX-5KE (2012-2017)

Share with friends on social networks:

Link in different formats to this section

TEXTHTMLBB Code