External elements of the car body Mazda 121 (3)

General information about the car body
The body of these models is load-bearing. The bottom, side parts, roof and rear fenders are connected to each other by welding. The front and rear windows are glued into...

Precautions when working with body parts
Since sparks are generated during the welding process, it is necessary to completely disconnect the battery during work (both wires) and securely insulate the removed...

Removal and installation the front bumper and radiator grille
Removal Unhook the radiator grille from the four clamps and remove it. Remove both headlights. Raise and support the vehicle. Unscrew one resonator bolt. Remove the...

Removal and installation the rear bumper
Removal Disconnect the negative cable from the battery with the ignition off. This will erase the data from the electronic memory units. See the instructions in Chapter...

Removal and installation the inner parts of the front fenders
Removal Mark the position of the front wheel relative to the hub so that you can then install the balanced wheel in its original position. Loosen the wheel nuts with the...

Removal and installation the front wing
Removal Remove the front bumper. Remove the inner part of the wing. Remove the side turn signal. Carefully pull the wing, section by section. Installation Clean the wing...

Removal and installation the hood
1. Hood; 2. Loop; 3. Bolt with washer; 4. Hood support holder; 5. Rivet; 6. Compaction; 7. Compaction; 8. Thrust buffer; 9. Rubber bushing; 10. Hood support; 11. Hood...

Replacing the decorative strip
Place one piece of protective tape above and below the strip. This will protect the paint when removing it. It will also make it easier to install the new strip. Cut the...

Removal and installation the outside rearview mirror
Removal Disconnect the negative cable from the battery with the ignition off. Caution: This will erase the data from the electronic memory units. See the instructions in...

Replacing the mirror glass
Place the mirror glass with your hand down (throw down). Insert a thin flat-head screwdriver into the top outer corner of the mirror so that the tip of the screwdriver...

Ford KA car body — general information
Some operations on the Ford KA model body are practically the same as those described for the Ford Fiesta/Mazda 121 models. In this regard, only the previous chapter,...

Ford KA: Removing and installing the front bumper and radiator grille
Removal Mark the position of the front wheels on the hubs so that you can then install the balanced wheel in its original position. Loosen the wheel nuts with the car on...

Ford KA: Removing and installing the rear bumper
Removal Disconnect the negative cable from the battery with the ignition off. Note: This will erase the data in the electronic memory units. See the instructions in the...

Ford KA: Removing and installing the inner part of the front fender
Removal Mark the position of the front wheel on the hub so that you can then install the balanced wheel in its original position. Loosen the wheel nuts with the car on...

Ford KA: Removing and installing the outside rearview mirror
Removal Remove the cover of the manual control lever for the position of the outside mirror. Unhook the inner cover of the outside mirror with a screwdriver and remove...

Control dimensions of the body
Mazda 121 body Mazda 121 Bottom

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections on repairs of other Mazda models
• Body: Exterior (external elements) Mazda Capella 3 and 4 (1982-1992)
• Body: Exterior (external elements) Mazda6 GG (2002-2008)
• Body: Exterior (external elements) Mazda CX-5KE (2012-2017)

Share with friends on social networks:

Link in different formats to this section

TEXTHTMLBB Code