Car Manual Introduction Mazda BT-50 1

Vehicle Identification Number
The vehicle identification number is stamped on the frame of the vehicle on the right side. The identification plate with the vehicle identification number is located on...

Engine number
The engine number is stamped on the cylinder block; the location of the number is shown in the figure by an arrow. WL-C Engine

Technical characteristics of the engines installed on the car
Note: The given power and torque values are approximate and may vary depending on the specific modification and year of manufacture, but in most cases the error does not...

Abbreviations and symbols
Abbreviations A/C - air conditioner ABS — anti-lock braking system EGR - exhaust gas recirculation system MT - manual transmission RFW — Front Axle Disconnect System VSC...

General repair instructions
1. Use fender covers, seat covers and floor mats to protect your vehicle from dirt and damage. 2. When disassembling, arrange the parts in the proper order to facilitate...

Installation points for garage jack, lift legs and stands
1 - for 2WD models only, 2 - for 4WD models only, 3 - for 2WD and 4WD models. Garage jack installation points. Installation points for the lift legs. Points for...

Main parameters of the car
Note: * - for Active configuration; ** - depending on the configuration.

Safety precautions when installing a mobile radio communication system
The electronic control unit is designed in such a way as to exclude the influence of external electromagnetic interference. However, if the vehicle is equipped with a CB...

Safety precautions when working with electrical equipment
1. Do not disconnect the battery while the engine is running, as this may damage the electrical components of the vehicle. 2. Do not touch moving parts in the engine...

Safety precautions when equipped with SRS (airbags)
Warning: Accidental deployment of the airbag or seat belt pretensioner can result in serious injury, so be sure to read and follow all safety precautions in this...

Safety precautions when working with the fuel system
1. Before working on the fuel system, disconnect the negative cable from the battery. Note: Be sure to read diagnostic codes before disconnecting the battery cables. 2....

Precautions when working with oils
1. Long-term and repeated contact with mineral oil will strip the natural fats from human skin, causing dryness, irritation and dermatitis. In addition, the motor oils...

Safety precautions when working with the air supply system
1. Removing the engine oil dipstick, oil filler cap, hoses, etc. from a running engine may cause engine adjustments to become out of adjustment. 2. Disconnection,...

Safety precautions when working with refrigerant
Always follow safety precautions when working with refrigerant. 1. Do not work with refrigerant in a closed room or near an open flame. 2. Always wear safety glasses. 3....

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections on repairs of other Mazda models
• General information: Introduction to guide Mazda Familia 6 (1989-1994)
• General information: Introduction to manual Mazda Capella 4 (1987-1992)
• General information: Introduction to the guide Mazda CX-5KE (2012-2017)

Share with friends on social networks:

Link in different formats to this section

TEXTHTMLBB Code