Car steering Mazda BT-50 1

Power steering pump drive belt
The procedures for checking and adjusting the power steering pump drive belt are described in Chapter " Maintenance and general check and adjustment procedures ".

Checking for leaks of working fluid
1. Start the engine and let it idle. 2. To increase the fluid pressure, turn the steering wheel to the right and left several times until it stops. 3. Make sure there...

Checking the working fluid pressure
1. Assemble the pressure gauge and adapters to check the working fluid pressure. 2. Disconnect the discharge hose. Note: Make alignment marks before disconnecting the...

Checking the steering wheel play
1. With the front wheels in a straight-ahead position, gently turn the steering wheel to the right and left to make sure that the steering wheel play does not exceed the...

Checking the steering wheel effort
1. Place the vehicle on a level, hard surface. 2. Start the engine and warm up the power steering fluid to 50-60°C. Note: To warm up the fluid, turn the steering wheel...

Removal and installation the steering column and steering wheel
Removal and installation of the steering column and steering wheel. 1 - lower trim on the driver's side, 2 - steering wheel cover, 3 - driver's airbag, 4 - nut, 5 -...

Bleeding the power steering system
1. Check the fluid level in the tank (see chapter " Maintenance and general check and adjustment procedures "). If necessary, bring the fluid level up to normal....

Steering column and steering wheel — removal and installation
Warning: Careless handling of the airbag may cause it to deploy unintentionally, which may cause serious injury. Before removing the airbag, read the section "...

Steering column and steering wheel — check
1. Perform the following checks and replace the steering shaft assembly if necessary. a) Check that the steering column bearing and bushings are not damaged. b) Check...

Steering gear and rods — removal and installation
Note: Carrying out repairs without first removing the ABS wheel speed sensor may damage the sensor wiring. To prevent damage to the sensor or its wiring, remove the...

Steering gear and rods — disassembly and assembly
Remove the parts in the order they are numbered in the assembly drawing "Steering gear". Steering gear. 1 - nut, 2 - steering knuckle, 3 - nut, 4 - sector shaft, 5 -...

Steering gear and rods — check
Check the tie rod ends. a) Check the steering tie rod end for cracks on the boot and other damage. If any faults are found, replace the boot. b) Check the ease of...

Power Steering Pump — Removal and Installation
1. Remove the battery and battery tray (see the chapter "Maintenance and General Checking and Adjusting Procedures"). 2. Remove the fasteners shown in the figure. 3....

Power Steering Pump — Disassembly and Assembly
Remove the parts in the order they are numbered in the "Power Steering Pump" assembly drawing. Power steering pump. 1 - hairpin, 2 - power steering pump assembly, 3 -...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections on repairs of other Mazda models
• Chassis: Steering Mazda Familia 5 (1985-1989)
• Chassis: Steering system Mazda Capella 4 (1987-1992)
• Chassis: Steering Mazda3 BK (2003-2009)
• Chassis: Steering Mazda6 GG (2002-2008)
• Chassis: Steering Mazda CX-5KE (2012-2017)

Share with friends on social networks:

Link in different formats to this section

TEXTHTMLBB Code