Car front suspension Mazda BT-50 1

Checking and adjusting the front wheel alignment angles
Preliminary checks 1. The vehicle must be parked on a level surface when unloaded. Note: * - the fuel tank is fully filled, the engine has the set level of coolant and...

Front suspension — device
Front suspension component locations. 1 - front suspension shock absorber, 2 - torsion bar and lower arm of the front suspension, 3 - upper arm of the front suspension,...

Checking the hub bearing
1. By pushing and pulling the wheel hub with your hands in the axial direction, check for axial clearance in the hub bearing. 2. Make sure that the wheel rotates...

Replacing the wheel mounting stud
Note: Replace the wheel stud only when necessary. 1. Remove the brake caliper and brake disc. 2. Using a puller, press the wheel mounting stud out of the hub. 3. Install...

Front wheel hub and steering knuckle — device
Front wheel hub and steering knuckle. 1 - hub nut, 2 - brake caliper, 3 - brake disc, 4 - steering rod end, 5 - suspension stabilizer bolt, 6 - shock absorber mounting...

Front Wheel Hub and Steering Knuckle — Removal
Note: Carrying out repairs without first removing the ABS wheel speed sensor may damage the sensor wiring. To prevent damage to the sensor or its wiring, remove the...

Front suspension shock absorber
Removal and installation Remove the parts in the order they are numbered in the assembly drawing "Removing and installing the front suspension shock absorber". Removal...

Front Wheel Hub and Steering Knuckle — Installation
1. Install the mudguard. a) Place a mark on the new shield in the same location as on the old one. b) Align the marks on the new shield and steering knuckle. c) Using...

Front suspension anti-roll bar
Removal and installation Remove the parts in the order they are numbered in the assembly drawing "Removing and installing the front suspension anti-roll bar". Note:...

Torsion bar and lower control arm front suspension
Removal and installation Note: Carrying out repairs without first removing the ABS wheel speed sensor may damage the sensor wiring. To prevent damage to the sensor or...

Upper control arm front suspension
Removal and installation Note: Carrying out repairs without first removing the ABS wheel speed sensor may damage the sensor wiring. To prevent damage to the sensor or...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections on repairs of other Mazda models
• Chassis: Front suspension Mazda Familia 6 (1989-1994)
• Chassis: Front suspension Mazda Capella 4 (1987-1992)
• Chassis: Front suspension Mazda CX-5KE (2012-2017)

Share with friends on social networks:

Link in different formats to this section

TEXTHTMLBB Code