Car front suspension Mazda 323 (BG)

Description of the front suspension
1 - stabilizer; 2 - rubber bushing; 3 - lower arm; 4 - ball joint; 5 - mounting plate; 6 - upper spring cup; 7 - rubber gasket; 8 - shock absorber and casing; 9 - coil...

Removal and installation the shock absorber strut
Removal 1. Loosen the wheel nuts with the vehicle parked on the ground. 2. Mark the position of the wheel disks in relation to the hub. Thanks to this, the balanced...

Disassembling the shock absorber / removing and installing the shock absorber / coil spring
Removal 1. Remove the shock absorber strut. 2. Remove the cap from the shock absorber rod. 3. The coil spring is compressed. To release the shock absorber, the spring...

Checking the shock absorber
The following signs indicate a faulty shock absorber: Long-term vibration of the body when the road is uneven. The body sways when there are successive unevennesses in...

Removal and installation the wishbone / replacing the rubber support
Since the vehicle must be on its wheels to tighten the rubber mounts, either a lift with a platform or an inspection pit is required. Removal 1 - stabilizer nut; 2 -...

Checking/replacing the wishbone/steering knuckle support
1. Remove the wishbone and check both rubber mounts for cracks, damage and deformation. 2. Replacing the rear rubber support: Unscrew the nut "7", remove the washer and...

Removal and installation the drive shaft
1 - wheel; 2 - mudguard; 3 - hub nut; 4 - stabilizer; 5 - steering rod end; 6 - steering knuckle; 7 - left drive shaft; 8 - right drive shaft lubricate (lithium...

Removal and installation the intermediate shaft
All-wheel drive and DOHC models Vehicles with a 1.9L DOHC engine and/or all-wheel drive have an intermediate shaft between the transmission and the right drive shaft,...

Checking/disassembling the drive shaft/replacing the seals
Drive shaft with internal joint type "star" (tripod joint) 1 - cuff clamp; 2 - cuff clamp; 3 - bracket; 4 - hinge housing; 5 - retaining ring; 6 - tripod joint; 7 -...

Front hub bearing
Cars up to 9/89 and station wagon models: separate bearing 1 - wheel hub; 2 - brake disc; 3 - spacer element; To adjust the bearing pre-tension.; 4 - outer bearing cage;...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections on repairs of other Mazda models
• Chassis: Front suspension Mazda Capella 4 (1987-1992)
• Chassis: Front suspension Mazda CX-5KE (2012-2017)
• Chassis: Front suspension Mazda BT-50 (1) (2006-2011)

Share with friends on social networks:

Link in different formats to this section

TEXTHTMLBB Code