Description of the rear suspension The rear wheel suspension consists of a suspension strut, two lower wishbones and a trailing bar. Both sides are connected by a stabilizer bar that reduces body lean...
Removal and installation of a back amortization rack Removing 1. If necessary, remove the side upholstery in the cabin to get to the upper bolts of the suspension strut. 2. Loosen the wheel nuts of the car standing on the...
Wishbones / trailing arm / stabilizer Front wheel drive vehicles Attention! After loosening the transverse/trailing arms, the rubber mounts can only be tightened if the vehicle is on wheels. Then you should...
Checking the rear wheel bearing A symptom of a bad wheel bearing is an unusual driving noise that only starts at a certain point (high) speed. Examination 1. Release the handbrake. 2. Raise the rear of...
Removal and installation of the bearing of a back nave Cars up to 9/89, issue. and models "station wagon" (not all-wheel drive) Cages of a two-component wheel bearing on cars up to 9/89, issue. located in the brake drum, on...
Rear wheel bearing play adjustment Cars up to 9/89, issue. and all models "station wagon" (not all-wheel drive) 1. Change the position of the wheel disk relative to the hub so that the balanced wheel can...
Removal and installation of a back nave Vehicles since 10/89 (not all-wheel drive), except models "station wagon" The hub bearing on vehicles from 10/89 is located in the hub, on which the brake drum or brake...