Front wheel drive cars
Caution! After loosening the transverse/longitudinal arms, the rubber supports may only be tightened if the vehicle is standing on its wheels. The wheel alignment angles should then be measured in a workshop.
1 - stabilizer nut; Screw on until the thread protrudes approximately 18 mm.; 2 - sleeve, bushing, spacer element; 3 - bolt; 4 - cap; 5 - nut; 6 - washer; 7 - bolt; 8 - lock washer; 9 - Front wishbone; 10 - rear wishbone; The length can be adjusted to adjust the toe-in using an eccentric sleeve (up to 9/89.) or threaded rod (starting from 10/89 issue.).; 11 - bolt, washer; 12 - longitudinal lever