Steering of cars Mazda 323 (BF)

Detailed technical specifications of the steering system
Steering with rack and pinion steering mechanism, the gear ratio of which, depending on the modification, can be constant or variable. The steering shaft consists of an...

Components of a mechanical steering gear with a constant gear ratio
Components of a mechanical steering gear with a constant gear ratio: 1 - crankcase; 2 - rail; 3 - mounting bracket; 4, 5 - rubber bushings; 6 - rack support sleeve; 7 -...

Variable ratio mechanical steering gear parts
Variable ratio mechanical steering gear parts: 1 - crankcase; 2 - rail; 3 - mounting brackets; 4, 5 - rubber bushings; 6 - rack support sleeve; 7 - lock washer; 8 -...

Steering column parts
Steering column details: 1 - casing with upper steering shaft; 2 - steering wheel; 3 - steering shaft mounting bracket; 4 - steering column angle adjustment lever; 5 -...

Removal and installation of mechanical steering
Removal Place the front of the car on stands and remove the wheels. Slide the cabin seal boot onto the steering shaft. Loosen the bolt securing the lower steering shaft...

Disassembly, inspection and assembly of a constant ratio steering gear
Disassembly Remove the clamps securing the steering rod protective boots and slide the boots over the rods. Turn the rack pinion until the limiting ring stops in the...

Disassembly, inspection and assembly of the variable ratio steering gear
Disassembly, inspection of the technical condition and assembly of the steering gear with a variable gear ratio is carried out in the same way as for the steering gear...

Removal and installation the steering column
Disconnect the wires from the battery terminals. Remove insert 1 ( see picture ) steering wheel by unscrewing screws 2. Unscrew nut 3 securing steering wheel 2 and...

Power Steering Details
Power steering parts: 1 - steering gear housing; 2 - rail; 3 - mounting brackets with rubber bushings; 4 - rings and support sleeve of the rack; 5 - steering rods; 6 -...

Removal and installation power steering
Removal and installation of the power steering are carried out in the same way as when removing and installing mechanical steering , taking into account the following:...

Removal and installation a power steering column
Removal and installation of the steering column of the power steering are performed in the same way as for mechanical steering .

Bleeding the Power Steering System
Notes: 1. It is prohibited to reuse drained oil. 2. It is necessary to thoroughly wash the power steering reservoir filter with a fat solvent, such as white spirit....

Checking the operating pressure of the power steering
Disconnect the high-pressure line from the steering gear housing and connect special tool 49 1232 670A with adapter fittings 49 B 032 302 and 40 H 002 671 to the line...

Adjusting the tension of the power steering pump drive belt
Loosen mounting bolt 1 (see picture) pump and lock nut 2 of the tensioner. Using adjusting screw 3, achieve belt deflection within 8-10 mm with a force of 10 kgf....

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections on repairs of other Mazda models
• Chassis: Steering system Mazda Capella 4 (1987-1992)
• Chassis: Steering Mazda3 BK (2003-2009)
• Chassis: Steering Mazda6 GG (2002-2008)
• Chassis: Steering Mazda CX-5KE (2012-2017)
• Chassis: Steering Mazda 121 (3) (1996-2003)

Share with friends on social networks:

Link in different formats to this section

TEXTHTMLBB Code