Battery, alternator and starter Mazda 323 (BG)

Removal and installation the battery
Attention! When the battery is disconnected, the data from the fault memory of the engine control unit, anti-lock braking system, and other constantly operating devices...

Checking the battery
There are two ways to test a battery. Depending on the method of testing, different measuring devices are needed. Checking the density of the electrolyte 1. Checking the...

The battery discharges itself
Depending on the vehicle's equipment, the battery's self-discharge is supplemented by the energy consumption of constantly operating consumers. Therefore, the battery in...

Charging the battery
1. Never short-circuit the battery, this means not connecting the positive and negative poles. When short-circuited, the battery heats up and can explode. Do not shine...

Storage of the battery
Batteries that are not used for a long time discharge themselves and may be subject to sulfation. If such batteries are charged with a fast charger, they do not accept...

General description of the generator
MAZDA 323 is equipped with an alternator. Depending on the model and equipment, generators with a capacity of 55 A or 65 A can be installed. The capacity is indicated on...

Safety Precautions for Alternator
When working on the electrical system in the engine compartment, be sure to disconnect the battery ground cable. Attention! This will erase the data from the memory of...

Checking the generator voltage
1. Connect a voltmeter between the positive and negative terminals of the battery. 2. Start the engine. When starting, the voltage should not fall below 8 V (at an...

Removal and installation the generator
Gasoline engine Removal 1. Disconnect the ground cable from the battery. Warning! This will erase the engine fault memory or the radio security code. Before...

Generator components
1. Put on the oil hoses and secure with clamps or screw on union nuts. Check the oil level, top up if necessary. 2. Put on the vacuum hoses and secure with clamps. 3....

Disassembling the generator / replacing carbon brushes
Generator carbon brushes wear out quite slowly; on average every 120,000 km. It is recommended to replace the brushes a little earlier, for this the generator must be...

Removal and installation the starter
A starter is required to start an internal combustion engine. The starter must accelerate the engine to 300 rpm. This only happens when the starter is working perfectly...

Checking/replacing the starter solenoid relay
Wiring diagram If the traction relay is faulty, the gear in the starter does not enter the flywheel ring gear. Because of this, the starter cannot turn the crankshaft....

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections on repairs of other Mazda models
• Electrical equipment: Power devices Mazda Capella 3 and 4 (1982-1992)
• Electrical equipment: Power devices Mazda3 BK (2003-2009)
• Electrical equipment: Power devices Mazda6 GG (2002-2008)
• Electrical equipment: Power devices Mazda 121 (3) (1996-2003)

Share with friends on social networks:

Link in different formats to this section

TEXTHTMLBB Code