Car heating system Mazda 323 (BG)

Description and device of the heater
Heater For heating, fresh air is sucked under the windshield and enters the car interior through the fan. The air passes through the heater body and is distributed...

Heater Fan Motor
MAZDA 323 since 10/89. 1 - preliminary resistors; 2 - fan housing; 3 - fan impeller; 4 - fan motor; 5 - fresh/circulated air damper Attention! If the heater fan does not...

Removal and installation the heater fan
Since 10/89 issue. Removal 1. Disconnect the ground cable from the battery. Warning! This will erase the engine fault memory or the radio security code. Before...

Heater control unit
MAZDA 323 since 10/89. 1 - button; 2 - overlay; 3 - body; 4 - fresh/circulated air flap cable; 5 - air distribution flap cable; 6 - temperature control cable; 7 -...

Adjusting heater drives
Since 10/89 issue. Fresh/Recirculated Air Damper Cable 1. Set the fresh/circulated air lever to fresh air. 2. Connect the cable to the fresh/circulated air damper rod....

Checking the fan motor/pre-resistors
Attention! If the fan does not work only on one stage, as a rule, the pre-resistor is faulty. In this case, replace all pre-resistors. Remove the glove compartment, see...

Checking the heater switch
1. Remove the control unit. 2. Disconnect the plug from the fan switch. 3. With the switch in the following positions, check the current flow between the corresponding...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections on repairs of other Mazda models
• Body: Air conditioning and heater Mazda3 BK (2003-2009)

Share with friends on social networks:

Link in different formats to this section

TEXTHTMLBB Code