Car steering Mazda 323 (BG)

Steering Description
The steering system consists of a steering wheel, a steering shaft, a steering gear, and tie rods. The steering wheel is screwed to the shaft, which leads to the...

Removal and installation the steering wheel
Removal 1. Set the wheels to the middle position. 2. Disconnect the ground cable from the battery. Warning! This will erase the engine fault memory or the radio security...

Removal and installation the steering rod end
Removal 1. Loosen the wheel nuts of a vehicle parked on the ground. 2. Change the position of the wheel disk relative to the hub so that the balanced wheel can be...

Removal and installation the steering gear rubber cuff
Removal 1. Remove the tie rod end. 2. Loosen the clamps at both ends of the cuff. Squeeze the clamps with pliers, or unscrew the wire clamps. 3. Remove the rubber cuff....

Servo control pump
Note: For filling the servo control system/V-belt tensioning, see Section Routine maintenance . Cars up to 9/89 issue and "station wagon" models 1 - adjusting screw; 2 -...

Wheel alignment angles
Optimal driving characteristics and minimal tire wear are only achieved with correct front wheel alignment. In case of abnormal tire wear, poor road holding - poor...

Values for checking wheel alignment
Certain conditions must be met during the check Model Parameter Front suspension value for adjustment Rear suspension value for adjustment Front-wheel drive from 8/85 to...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections on repairs of other Mazda models
• Chassis: Steering Mazda Capella 6 (1997-2005, petrol)
• Chassis: Steering Mazda3 BK (2003-2009)
• Chassis: Steering Mazda6 GG (2002-2008)
• Chassis: Steering Mazda CX-5KE (2012-2017)
• Chassis: Steering Mazda BT-50 (1) (2006-2011)

Share with friends on social networks:

Link in different formats to this section

TEXTHTMLBB Code