Car steering Mazda CX-5 (KE)
Technical data
1. Steering wheel and steering column. 2. Electric power steering control unit. 3. Intermediate shaft. 4. Steering gear with rods. Electric Power Steering Wiring Diagram
1. Steering wheel and steering column. 2. Electric power steering control unit. 3. Intermediate shaft. 4. Steering gear with rods. Electric Power Steering Wiring Diagram
General steering procedures
Attention. It is essential to thoroughly check all steering system components for impact marks that may occur as a result of accidents or service work. Use of damaged or...
Attention. It is essential to thoroughly check all steering system components for impact marks that may occur as a result of accidents or service work. Use of damaged or...
Checking the steering wheel and steering column
Checking the play 1. With the front wheels in the straight-ahead position, start the engine. 2. Carefully turn the steering wheel left and right to ensure that the...
Checking the play 1. With the front wheels in the straight-ahead position, start the engine. 2. Carefully turn the steering wheel left and right to ensure that the...
Removal the steering wheel and steering column
Attention. Failure to follow safety precautions when handling air bag modules can result in serious injury. Before working on air bag modules, be sure to read the...
Attention. Failure to follow safety precautions when handling air bag modules can result in serious injury. Before working on air bag modules, be sure to read the...
Installing the steering wheel and steering column
Installation is carried out in the reverse order of removal, taking into account the following features: Place the spacer and the elastic element on the steering column....
Installation is carried out in the reverse order of removal, taking into account the following features: Place the spacer and the elastic element on the steering column....
Removal and installation the intermediate shaft of the steering column
1. Hinge cover. 2. Intermediate shaft. Note: replace the part with a new one after each removal. Caution: Immediately after prolonged rotation of the steering gear, the...
1. Hinge cover. 2. Intermediate shaft. Note: replace the part with a new one after each removal. Caution: Immediately after prolonged rotation of the steering gear, the...
Replacing tie rod ends
1. Remove the cotter pin from the tie rod end nut. 2. Loosen the tie rod end nut. 3. Using a special puller, disconnect the steering rod end from the steering knuckle....
1. Remove the cotter pin from the tie rod end nut. 2. Loosen the tie rod end nut. 3. Using a special puller, disconnect the steering rod end from the steering knuckle....
Removal and installation the steering gear with rods
1. Bolts for fastening the relay gearbox to the subframe. 2. Steering gear with rods assembled. Removal the steering gear with rods in assembly Attention. There is a...
1. Bolts for fastening the relay gearbox to the subframe. 2. Steering gear with rods assembled. Removal the steering gear with rods in assembly Attention. There is a...
Disassembling the steering gear
1. Dust cover. 2. O-ring with circular cross-section. 3. Tie rod ends. 4. Locknuts. 5. Small dust boot clamps. 6. Large dust boot clamps. 7. Anther. 8. Steering rods. 9....
1. Dust cover. 2. O-ring with circular cross-section. 3. Tie rod ends. 4. Locknuts. 5. Small dust boot clamps. 6. Large dust boot clamps. 7. Anther. 8. Steering rods. 9....
Checking the steering gear components
Checking the tie rod end 1. Check the tie rod end for damage and the boot for cracks. If any defects are found, replace the tie rod end with a new one. 2. Check for...
Checking the tie rod end 1. Check the tie rod end for damage and the boot for cracks. If any defects are found, replace the tie rod end with a new one. 2. Check for...
Steering gear assembly
1. Steering gear. 2. Mounting bushings. 3. Steering rods. 4. Anthers. 5. Large dust boot clamps. 6. Small dust boot clamps. 7. Locknuts. 8. Tie rod ends. 9. O-ring with...
1. Steering gear. 2. Mounting bushings. 3. Steering rods. 4. Anthers. 5. Large dust boot clamps. 6. Small dust boot clamps. 7. Locknuts. 8. Tie rod ends. 9. O-ring with...
Checking the Electric Power Steering (EPS) Control Unit
1. Remove the front door sill trim on the driver's side. 2. Remove the front side trim on the driver's side. 3. Versions with navigation system: remove the vehicle's...
1. Remove the front door sill trim on the driver's side. 2. Remove the front side trim on the driver's side. 3. Versions with navigation system: remove the vehicle's...
This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
More sections on repairs of other Mazda models
• Chassis: Steering Mazda Familia 5 (1985-1989)
• Chassis: Steering Mazda Capella 3 (1982-1992, petrol)
• Chassis: Steering Mazda3 BK (2003-2009)
• Chassis: Steering Mazda6 GG (2002-2008)
• Chassis: Steering Mazda 121 (3) (1996-2003)
• Chassis: Steering Mazda Familia 5 (1985-1989)
• Chassis: Steering Mazda Capella 3 (1982-1992, petrol)
• Chassis: Steering Mazda3 BK (2003-2009)
• Chassis: Steering Mazda6 GG (2002-2008)
• Chassis: Steering Mazda 121 (3) (1996-2003)
Link in different formats to this section
TEXTHTMLBB Code
- General information
- Introduction to the guide
- User manual
- Maintenance
- Power unit
- Petrol engines 2.0 l
- Petrol engines 2.5 l
- Diesel engines 2.2 l
- Cooling system
- Lubrication system
- Supply system
- Control system
- Intake and exhaust system
- Engine electrical equipment
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Transfer case
- Drive shafts and cardan
- Chassis
- Wheels and tires
- Front suspension
- Rear suspension
- Brake system
- Steering
- Body
- Exterior (external elements)
- Interior (internal elements)
- Security systems
- Heating and air conditioning
- Electrical equipment
- Equipment and devices
- Electrical circuits
