Technical data Gasoline engine cooling system Diesel engine cooling system The cooling system of SKYACTIV family engines has the following features: The resistance to the passage of...
Safety Precautions When Working on the Cooling System Attention. Do not remove the cooling system cap or remove the radiator drain plug while the engine is running or when the engine and radiator are hot. Boiling coolant...
Checking the coolant level Attention. Observe safety measures when working with the engine cooling system. Note: If there is a symbol on or near the cooling system cap «FL22», FL22 coolant must be...
Coolant replacement Attention. Observe safety measures when working with the engine cooling system. Use coolant at a concentration suitable for the environment in which the vehicle is...
Coolant Density Check 1. Using a thermometer and a hydrometer, measure the temperature and density of the coolant. Attention. Use coolant at a concentration suitable for the environment in...
Checking the tightness of the cooling system Attention. Observe safety measures when working with the engine cooling system. 1. Check the coolant level. 2. Remove the engine cooling system cover. 3. Install the...
Checking the cooling system cover Attention. Observe safety measures when working with the engine cooling system. 1. Clean the cooling system cover and seal surfaces. 2. Check the cooling system cover...
Removal and installation of a radiator Attention. Observe safety measures when working with the engine cooling system. 1. Disconnect the negative battery terminal. 2. Remove the front protective tray No. 1 of...
Removing and installing the radiator fan motor 1. Radiator fan motor connectors. 2. Wiring harness. 3. Upper radiator hose. 4. Radiator fans assy. 5. Radiator fan #1. 6. Radiator fan #2. 7. Radiator fan motor #1. 8....
Checking the Radiator Fan Motor 1. Make sure the battery is fully charged. 2. Disconnect connector (2 pins) radiator fan motor. 3. Connect the tester and battery to the radiator fan connector according...
Removal and installation of the thermostat Attention. Observe safety measures when working with the engine cooling system. Removing the thermostat 1. Disconnect the negative battery terminal. 2. Drain the coolant...
Thermostat check 1. Remove the thermostat from the engine. 2. Visually verify that the thermostat valve is closed. 3. Place thermostat in water. Attention. During the test, the...
Removal and installation of the water pump Attention. Observe safety measures when working with the engine cooling system. Note: : replace the part with a new one after each removal. Do not disassemble the water...