Car front suspension Mazda CX-5 (KE)

Technical data
The car uses an independent front suspension with stabilizer struts with coil springs, with a subframe and an anti-roll bar. The subframe is attached to the body at six...

Tire pressure monitoring system
Note: When the tire pressure monitoring system is initialized, a learning procedure is started which is completed after the vehicle has been driven for 20 minutes. Until...

Removal/installing the front suspension strut
1. Front brake hose clamp. 2. Upper nut of the front anti-roll bar strut. 3. Dynamic damper (if equipped). 4. Lower bolts of the front shock absorber. 5. Upper nuts of...

Disassembly/assembly of the front suspension strut
Warning: Disassembly/assembly procedures - front suspension struts - are dangerous. Serious injury or death, as well as vehicle damage, may occur if the front shock...

Checking and disposing of the front shock absorber
Checking the front shock absorber 1. Remove the front shock absorber. 2. Check for damage and oil leaks. 3. Compress and extend the shock absorber piston rod at least...

Removal/installing the lower arm of the front suspension
1. Ball joint of the lower arm of the front suspension. 2. Lower arm of the front suspension. 3. Front suspension lower arm bushing. Note: : replace the part with a new...

Checking the lower arm of the front suspension
1. Remove the lower front suspension arm. 2. Check the lower arm of the front suspension for deformation or damage, and the ball joint of the lower arm for looseness. If...

Removal and installation the front anti-roll bar
1. Stand of the front stabilizer bar. 2. Dynamic damper (if equipped). 3. Front subframe assembly. 4. Front anti-roll bar bracket. 5. Front anti-roll bar bushings. 6....

Checking the front anti-roll bar struts
1. Remove the front anti-roll bar struts. 2. Check the stabilizer struts for deformation or damage. If any defects are found, replace the front stabilizer strut with a...

Removal and installation the front suspension subframe
1. Front suspension subframe assembly. 2. Front anti-roll bar. 3. Steering gear with rods. 4. Lower arm of the front suspension. 5. Engine mounting support No.1. 6....

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections on repairs of other Mazda models
• Chassis: Front suspension Mazda Familia 5 (1985-1989)
• Chassis: Front suspension Mazda Capella 4 (1987-1992)
• Chassis: Front suspension Mazda BT-50 (1) (2006-2011)

Share with friends on social networks:

Link in different formats to this section

TEXTHTMLBB Code

CX-5KE (2012-2017)