Car rear suspension Mazda CX-5 (KE)

Technical data
The rear suspension of the car is an E-shaped multi-link. The peculiarity of the suspension is that the rear subframe is stretched in the longitudinal direction, due to...

Removal and installation rear shock absorbers
1. Upper nuts of the rear shock absorber. 2. Lower bolt of the rear shock absorber. 3. Rear shock absorber. 1. Remove the appropriate wheel from the vehicle. 2. Unscrew...

Checking and disposing of the rear shock absorber
Checking the rear shock absorber 1. Remove the rear shock absorber from the vehicle. 2. Check the shock absorber for damage and oil leaks. 3. Compress and stretch the...

Removal and installation the rear suspension coil spring
1. Lower nut of the rear anti-roll bar. 2. Outer bolt of the lower arm of the rear suspension. 3. Upper rubber spring seat. 4. Rear suspension coil spring. 5. Lower...

Removal and installation the lower arm of the rear suspension
1. Lower nut of the rear anti-roll bar. 2. Outer bolt of the lower arm of the rear suspension. 3. Rear suspension coil spring assembly. 4. Inner nut of the lower arm of...

Upper arm rear suspension — front wheel drive (2WD) versions
Removal and installation the upper arm of the rear suspension 1. Upper arm of the rear suspension. 2. Rear suspension upper arm bushings. Note: : replace the part with a...

Removal and installation the upper arm of the rear suspension — versions with all-wheel drive (4WD)
1. Upper arm of the rear suspension. 2. Rear suspension upper arm bushing. Note: : replace the part with a new one after each removal. : use a special tool or device....

Removal and installation the rear suspension trailing arm
1. Rear suspension trailing arm mounting nuts. 2. Rear suspension trailing arm mounting bolts. 3. Rear suspension trailing arm. 1. Remove the supporting roof from the...

Removal and installation the rear suspension cross rod
1. Outer bolt of the rear suspension transverse tie rod. 2. Inner bolt of the rear suspension transverse tie rod. 3. Rear suspension transverse rod. 1. Loosen the lower...

Removal and installation the rear anti-roll bar
Front-wheel drive version (2WD): 1. Rear transverse stabilizer bar. 2. Rear anti-roll bar assembly. 3. Rear anti-roll bar brackets. 4. Rear anti-roll bar bushings. 5....

Checking the front anti-roll bar struts
1. Remove the front anti-roll bar struts. 2. Check the stabilizer struts for deformation or damage. If any defects are found, replace the front stabilizer strut with a...

Rear suspension subframe
Front-wheel drive version (2WD): 1. Rear subframe assembly. 2. Rear anti-roll bar assembly. 3. Upper rear suspension arm assembly. 4. Rear subframe mudguard. 5. Rear...

Special tools and accessories

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections on repairs of other Mazda models
• Chassis: Rear suspension Mazda Familia 6 (1989-1994)
• Chassis: Rear suspension Mazda Capella 4 (1987-1992)
• Chassis: Rear suspension Mazda BT-50 (1) (2006-2011)

Share with friends on social networks:

Link in different formats to this section

TEXTHTMLBB Code

CX-5KE (2012-2017)