Front-wheel drive version (2WD):
1. Rear subframe assembly.
2. Rear anti-roll bar assembly.
3. Upper rear suspension arm assembly.
4. Rear subframe mudguard.
5. Rear subframe.
1. Rear subframe assembly.
2. Rear anti-roll bar assembly.
3. Upper arm of the rear suspension.
4. Rear subframe mudguard assembly.
5. Rear final drive mounting support.
6. Rear final drive.
7. Rear subframe.
Removal and installation the rear subframe
The primary source is the website [mazbook.ru]
Caution: Removing the subframe is dangerous. The subframe assembly may fall and cause serious injury or death. Make sure the jack is securely supporting the subframe assembly.
1. Perform the procedures for removing the rear anti-roll bar.
2. Remove all necessary components from the subframe.
3. Installation is performed in the reverse order of removal. After installation, check and, if necessary, adjust the wheel alignment angles.