Rear suspension of the car Mazda 626 (4)

Rear wheel suspension
The rear wheel suspension of a vehicle with conventional two-wheel steering consists of two transverse suspension arms arranged parallel from the inside out, trailing...

Rear wheel hubs and wheel bearings
15.1.1. Removing the brake drum and wheel hub To check the rear wheel bearing for wear or damage, you need to place the rear of the car on jack stands, grab the wheel...

Rear shock absorbers and struts
15.2.1. Removal Since the removal of one part affects the removal of another, the work is described together; in general, the shock absorber strut is attached in the...

Rear wishbones and connecting rods
15.3.1. Removal In normal two-wheel control, the setup shown in the figure is 203 lower wheel suspension. As you can see in the picture, one of the suspension arms can...

Suspension arms and trailing arm rod
The rear wheel suspension shown in Figure 204 is installed on a vehicle with four-wheel steering. As can be seen in the picture, only one wishbone is installed. The...

Anti-roll bar
Removal and installation of the anti-roll bar for conventional two-wheel steering is carried out in a similar manner as described for the front anti-roll bar ( chapter...

Removal and installation the rear carrier shaft
The carrier shaft, i.e. the entire wheel hub support, must be replaced if the support rings on it have rotated, the threads of the nuts are damaged, and the carrier...

Rear wheel geometry
The rear wheel camber is set at the factory and cannot be adjusted. The rear wheel toe-in should be measured if the wishbone has been removed or, in the case of a...

Brake system — design features
Most models use disc brakes on the front wheels and self-aligning drum brakes on the rear wheels. Certain models are designed with ventilated disc brakes on the front...

Front wheel brakes
Disc brakes use sliding calipers with two self-adjusting brake pads, one on each side of the brake disc. A separate piston acts directly on the brake pad and the...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections on repairs of other Mazda models
• Chassis: Rear suspension Mazda Familia 5 (1985-1989)
• Chassis: Rear suspension Mazda CX-5KE (2012-2017)
• Chassis: Rear suspension Mazda 121 (3) (1996-2003)

Share with friends on social networks:

Link in different formats to this section

TEXTHTMLBB Code

Capella 5 (1991-1997)