Clutch and axle shafts of the car Mazda 626 (5)

Technical specifications
Clutch pedal free play 1 – 3 mm Clutch pedal height – models produced between 1993 and 1997 175 – 224 mm – 1998 models 175 – 200 mm Axle shafts Length of axle shafts:...

Clutch check
All models with a manual transmission are equipped with a dry, single-plate clutch with a diaphragm spring and hydraulic clutch release. Examination 1. When checking the...

Clutch release cylinders
Clutch release master cylinder Removal 1. Disconnect the negative battery cable. 2. Disconnect the cylinder rod from the clutch pedal and unscrew the mounting nut under...

Hydraulic clutch release drive system
Pumping 1. Fill the reservoir with new hydraulic fluid. 2. Place a piece of hose onto the bleed valve and lower the end of the hose into a container of hydraulic fluid....

Clutch mechanism components — removal and installation
Pressure plate wear 1. Normal wear of the spring plates 2. Excessive wear 3. Excessive wear of the spring plates 4. Broken or bent plates Clutch disc 1. Friction...

Release bearing and release bearing fork
Removal 1. Remove the clutch release slave cylinder. 2. Remove the gearbox. 3. Remove the bearing fork from the ball joint, press on the spring and remove the release...

Adjusting the clutch pedal
Clutch pedal 1. Tighten the clutch master cylinder rod to adjust the pedal free play. 2. Tighten the adjusting bolt to adjust the pedal height. Clutch pedal height...

Interlock switch
Interlock switch connection connectors 1. 3-pin connection connector 2. 5-pin connection connector Examination Check that the switch closes the circuit when the clutch...

Axle shafts — removal and installation
The drive is transmitted to the wheels from the gearbox through a pair of half shafts. Constant velocity joints are installed at the ends of the axle shafts....

Intermediate shaft — removal and installation
Removal 1. Disconnect the inner end of the right axle shaft from the intermediate shaft. 2. Loosen the intermediate bearing mounting bolts; the bolts must be tightened...

Axle shaft boots — replacement
Replacement 1. Remove the axle shaft from the vehicle. 2. Clamp the axle shaft in a vice. Inner CV joint Tripod type hinge Removal elements 1. Remove the boot mounting...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections on repairs of other Mazda models
• Transmission: Clutch Mazda Familia 5 (1985-1989)
• Transmission: Clutch Mazda3 BK (2003-2009)
• Transmission: Clutch Mazda6 GG (2002-2008)
• Transmission: Clutch Mazda CX-5KE (2012-2017)
• Transmission: Clutch Mazda 121 (3) (1996-2003)

Share with friends on social networks:

Link in different formats to this section

TEXTHTMLBB Code

Capella 5 (1991-1997)