External body elements Mazda 626 (5)

General information about the body
A characteristic feature of the car models described in this manual is the presence of a "Unibody" type design, which uses a trough-shaped element of the body floor...

Body maintenance and repair
The condition of your car's body is very important because it largely determines its resale value. It is much more difficult to repair a neglected or damaged body than...

Vinyl trim
Never clean vinyl trim with detergents, caustic soaps, or kerosene-based cleaners. Simple soap and water work great, and a soft brush can easily remove stubborn dirt....

Repair of minor body damage
Repair of minor scratches If the scratch is superficial and does not affect the body metal, repair is very simple. Lightly buff the scratched surface with a fine...

Repair of significant body damage
Significant damage to the body must be repaired at service stations that have equipment for body repair. If there is extensive damage, it is necessary to check the...

Replacing the radiator grille (Mazda 626 model)
1. Open the hood. 2. Unscrew the central mounting screw. Release the two retaining clips and remove the grille. 3. Insert the grille into place until the latches lock...

Hood — removal, installation and adjustment
Removal 1. Open the hood. 2. Disconnect any wires or hoses that may interfere with removing the hood. 3. Mark the installation position of the hinges on the hood. 4....

Bumpers — removal and installation
Front bumper 1. Raise the vehicle and support it on supports. 2. Disconnect the battery and wait a few minutes. 3. Remove the air dam, radiator, and bumper mounting...

Front fender — removal and installation
Removal 1. Raise the vehicle and support it on supports. 2. Remove the front bumper cover. 3. Loosen the mounting screws (indicated by arrows) and remove the wheel arch...

Plastic panel in front of the windshield
Removal 1. Loosen the mounting nuts and remove the wiper arms. 2. Remove the caps, unscrew the mounting screws and remove the panel. Installation 3. Installation is...

Rearview mirrors — removal and installation
External rearview mirrors 1. On models with power mirrors, remove the door trim panel. 2. Remove the side panel. 4. Disconnect the mirror connection connector (A),...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections on repairs of other Mazda models
• Body: Exterior (external elements) Mazda6 GG (2002-2008)
• Body: Exterior (external elements) Mazda CX-5KE (2012-2017)
• Body: Exterior (external elements) Mazda BT-50 (1) (2006-2011)

Share with friends on social networks:

Link in different formats to this section

TEXTHTMLBB Code

Capella 5 (1991-1997)