Car suspension Mazda 626 (6)

Suspension and steering technical data
Tightening torques for connections, Nm Front suspension Suspension arm: Inner hinge bolts: Front - 79-106 Rear - 94-130 Steering knuckle ball joint nut — 34-57 Anti-roll...

Basic information about suspension and steering
The front suspension (Fig. 1.1) is a MacPherson strut. The upper end of the strut is attached to the car body. The lower strut mount is attached to the steering knuckle....

Front suspension strut — removal, inspection and installation
Removal 1. Loosen the front wheel nuts, lift the vehicle and place it on supports. Remove the wheels. 2. Disconnect the brake hose from the strut bracket (figure 2.2)....

Strut spring — replacement
1. If the shock absorber or strut springs are faulty (cracks, fluid leaks, loss of resistance), explore the possibility of purchasing a stand before you begin. A faulty...

Steering knuckle — removal and installation
Caution! Dust generated by brake pad wear may contain asbestos, which is hazardous to your health. Do not blow compressed air into the brakes or inhale the dust. Do not...

Front Hub and Bearing Assembly — removal and installation
Since separating the hub from the steering knuckle requires special tools, this work should only be performed by an experienced mechanic at a specialized service...

Front anti-roll bar — removal and installation
Removal 1. Loosen the front wheel nuts. Raise the front of the vehicle and support it on jack stands. Remove the front wheels. 2. Remove the cross member installed under...

Suspension arm — removal, inspection and installation
Removal 1. Loosen the wheel nuts. raise the front of the car and place it on supports. Remove the wheel. 2. Unscrew the nut securing the stabilizer bar link to the...

Ball joint — replacement
Cars of this model are equipped with maintenance-free ball joints. Defective supports are replaced together with the suspension arms. The crushing of the suspension arm...

Rear suspension strut — removal, inspection and installation
1. Loosen the rear wheel nuts, raise the rear of the vehicle and place it on supports. Remove the wheels. 2. Remove the retainer and disconnect the brake hose from the...

Rear hub support — removal and installation
1. Loosen the rear wheel nuts, raise the rear of the vehicle and place it on supports. Remove the wheels. 2. Remove the rear hub with bearing ( see paragraph 11 ). 3. On...

Rear Hub and Bearing Assembly — removal and installation
Note: The hub and bearing form a single, non-separable unit. If the hub or bearing is faulty, replace the entire unit. 1. Loosen the rear wheel mounting nuts. Raise the...

Rear anti-roll bar — removal and installation
1. Loosen the rear wheel nuts. Raise the rear of the vehicle and support it on stands. Remove the rear wheels. 2. Unscrew the nuts securing the earrings to the...

Rear suspension arms — removal and installation
1. Loosen the rear wheel nuts. Raise the rear of the vehicle and support it on stands. Remove the wheels. Transverse levers Front control arms 2. Unscrew the bolts...

Tires and Wheels — basic information
1. All vehicles described in this Manual are equipped with radial ply tires (figure 21.1). Using tires of a different size or type may affect the stability and handling...

Wheel alignment — basic information
Wheel alignment is the adjustment of the angles of the front wheels of the vehicle relative to the ground. Incorrect wheel installation affects not only the vehicle's...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections on repairs of other Mazda models
• Chassis: Suspension and wheels Mazda3 BK (2003-2009)
• Chassis: Suspension and wheels Mazda6 GG (2002-2008)

Share with friends on social networks:

Link in different formats to this section

TEXTHTMLBB Code

Capella 5 (1991-1997)