Car engine cooling system Mazda 626 (5)

Elements of the engine cooling system
Elements of the engine cooling system and air conditioning system 1. Radiator; 2. Refrigerator; 3. Radiator and refrigerator cooling fans; 4. Air conditioning compressor...

Technical specifications
Pressure under the radiator cap 13,5 – 17,8 psi Thermostat It's starting to open up 80°C Fully open 96°C Coolant type 1993 R-12 1994 R-134a Coolant capacity 0.8 liters...

Thermostat — checking and replacing
Caution! The engine must cool down completely. Examination 1. Measure the coolant level, check the drive belt tension and the operation of the temperature sensor. 2. If...

Cooling Fans — checking and replacing
Location of the engine fan relay In 1993 Probe models, the fan relay (indicated by the arrow) located in front of the radiator. On 1994 and later Probe models, the low...

Radiator and expansion tank — removal and installation
Radiator cap location On 4-cylinder models, the radiator cap is located on the right side, directly on the radiator, and the top hose is located on the left side. On...

Water pump — inspection and replacement
If the water pump is faulty, it must be replaced immediately, otherwise the engine may be seriously damaged due to overheating. Examination 1. Remove the timing belt...

Coolant temperature sensor
Location of sensors (4-cylinder models) A – Temperature indicator sensor B – Coolant temperature sensor C – Cooling fan sensor Location of sensors (6-cylinder models) A...

Engine oil cooler (6-cylinder models)
The oil cooler is secured between the oil filter and the oil filter adapter. Removal and installation 1. Remove the oil filter and drain the coolant. 2. Remove the heat...

Blower motor electrical circuit
Blower Fan Housing Components (Ford) A – Blower fan B – Fan resistor C – Fan motor connector D – High speed fan relay Checking the blower motor resistor Resistance...

Blower Motor — removal and installation
The models described in this manual are equipped with air cushions. Before starting work, be sure to turn off the airbag system to avoid their sudden deployment. Removal...

Heater and air conditioner control unit
Checking the voltage at the contacts of the 10-pin socket (Mazda) Mode Contact Voltage Air mixture control knob in any position 1A #6.0 Air mixture control knob in any...

Heater Radiator — removal and installation
Removal 1. Disconnect the negative battery cable. 2. Drain the coolant. 3. Remove the center console and instrument panel. 4. Disconnect the hoses from the heater unit...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections on repairs of other Mazda models
• Model «B» engine: Cooling and lubrication system Mazda Familia 5 (1985-1989)
• Power unit: Cooling system Mazda3 BK (2003-2009)
• Power unit: Cooling system Mazda6 GG (2002-2008)
• Power unit: Cooling system Mazda CX-5KE (2012-2017)
• Power unit: Cooling and lubrication system Mazda BT-50 (1) (2006-2011)

Share with friends on social networks:

Link in different formats to this section

TEXTHTMLBB Code

Capella 5 (1991-1997)