Manual gearbox Mazda 626 (3rd and 4th gen)

Manual transmission specifications
The gap between the reverse gear lever and the reverse gear gear is 0.1-0.32 mm The limit value is 0.5 mm The gap between the gear shift fork and the synchronizer is...

General description of a mechanical transmission
The models are equipped with a 4-speed or 5-speed manual transmission, which is a gearbox and differential unit. The drive is transmitted through the gearbox gears to...

Transmission brackets inspection and replacement
Inspection 1. Inspect the bracket by having an assistant move the transmission up and down. If the bracket rubber pad separates from the transmission or the transmission...

Gear Shift Lever Assembly — removal and installation
Gear shift lever assembly parts 1. Gear shift knob; 2. Case; 3. Bolts and nuts; 4. Drive rod; 5. Gear Shift Lever Components; 6. Bracket nuts; 7. Nut and washer; 8....

Transmission — removal and installation
Removal 1. Disconnect the negative battery cable. 2. Disconnect the speedometer drive cable, the reversing light switch and (where is it installed) 5th gear selection...

Transmission — overhaul
Location of transmission components 1. Back cover (5-speed gearbox); 2. Lock nut (5-speed gearbox); 3. Limiter (5-speed gearbox); 4. Spring pin (5-speed gearbox); 5....

Output shaft assembly — inspection and overhaul
1. Remove the output shaft ( Chapter 5 ). 2. Clamp the shaft in a vice using two dies to protect it from damage. Measure the gear clearances with a feeler gauge and...

Input shaft assembly — inspection and overhaul
Layout of input and output shaft components 1. Gear shift fork (3rd and 4th gears); 2. Locking sleeve; 3. Spring pin; 4. Tip; 5. Gear shift fork (1st and 2nd gears); 6....

Differential — inspection and overhaul
Location of differential assembly components 1. Differential bevel gears; 2. Thrust washer; 3. Spring pin; 4. Axle of satellites; 5. Thrust washer; 6. Satellites; 7....

Transmission — assembly
1. Install the drain plug. 2. Install the output shaft bearing outer race together with its gasket using a punch and hammer. 3. Install the differential bearing ring and...

Transmission seals — replacement
1. The input shaft seal can only be replaced after removing the transmission. Drive shaft seals can be replaced with the transmission installed. Proceed as described...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections on repairs of other Mazda models
• Transmission: Car gearbox Mazda Familia 6 (1989-1994)
• Transmission: Mechanical gearbox Mazda3 BK (2003-2009)
• Transmission: Mechanical gearbox Mazda6 GG (2002-2008)
• Transmission: Mechanical gearbox Mazda CX-5KE (2012-2017)
• Transmission: Car gearbox Mazda 121 (3) (1996-2003)

Share with friends on social networks:

Link in different formats to this section

TEXTHTMLBB Code

Capella 5 (1991-1997)