Electrical equipment and devices of car Mazda 626 (4)

Electrical system — general information
All vehicles covered in this owner's manual are equipped with a 12-volt electrical system. Current is supplied via the negative battery terminal. The battery is located...

Rechargeable battery
The installed 12-volt battery has 6 elements consisting of positive and negative plates, which are immersed in a sulfuric acid solution. The battery's job is to supply...

Safety precautions when working on a charging current installation
Before carrying out any work on the charging current installation, it is imperative to comply with the prescribed measures: Never disconnect the battery or voltage...

Checking the installed brushless alternator
During normal driving, the charge control lamp should be turned off. If this does not happen, there is a defect in the brushless alternator or voltage regulator. First,...

Removal and installation the battery
Removal and installation are carried out differently for petrol and diesel models. With a gasoline engine Disconnect the battery cable. Remove the wire plug from the...

Disassembling the generator
Subsequent work should be carried out in accordance with Figure 246. The figure shows a typical generator f. mazda, however, might have a few different parts that were...

Checking the details
18.2.5.1. Carbon brushes and brush holder crossbar Check the carbon brushes for good contact with the slip rings. Check the mobility of the carbon in the guides and, if...

Assembling the generator
Figure 246 should be used when assembling: Assemble the generator cover from the drive side. To do this, press the bearing with the sealed side towards the rotor. Screw...

Starter — general information
A pinion-type starter is installed in all vehicles covered in this manual. However, depending on the type of transmission installed and the model, starters of varying...

Removal and installation the starter
Removal and installation depends on the type of engine installed. Starter 0.85-0.95 kW This starter is installed in cars with 1.6L, 2.0L 8-valve and DOHC engines. Figure...

Disassembling the starter
Figure 255 shows the starter assembly diagram for a 1.6-liter, 2.0-liter, 8-valve, and DONS engine. Starters used on 12-valve and diesel engines have an additional...

Checking the starter parts
18.3.3.1 Brush mechanism The brushes must be longer than 17.0 mm. Check that the brushes move easily along the guides during installation by gently pulling the...

Assembling the starter
The starter is assembled in the reverse order of disassembly. The following points must be especially observed: Lightly lubricate the screw thread of the armature shaft...

Main fuse box
The main fuse box is located in the engine compartment or, depending on the version, in another location specified in the manual for the current model. The fuse...

Car windshield wiper
To remove the windshield wiper motor and arms, refer to Figure 264. Figure 264. Details of removal and installation of the windshield wiper. Carry out the work in the...

Headlights — removal and installation
18.6.1. Removal and installation Removal and installation can be carried out after removing the radiator grille. To do this, use a small screwdriver to press down on the...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections on repairs of other Mazda models
• Electrical equipment: Equipment and devices Mazda Familia 6 (1989-1994)
• Electrical equipment: Equipment and devices Mazda3 BK (2003-2009)
• Electrical equipment: Equipment and devices Mazda6 GG (2002-2008)
• Electrical equipment: Equipment and devices Mazda CX-5KE (2012-2017)
• Electrical equipment: Equipment and devices Mazda 121 (3) (1996-2003)

Share with friends on social networks:

Link in different formats to this section

TEXTHTMLBB Code

Capella 5 (1991-1997)