External body elements Mazda 626 (6)

Basic information about the car body
The models described in this Manual have a design with a "load-bearing" body, to the bottom of which, to strengthen the body, front and rear subframes are attached, on...

Car body maintenance
1. The general condition of the vehicle body is one of the parameters that determines its value. It is much cheaper to repair any of the vehicle's components than to...

Plastic body panels — care
Do not clean plastic panels with solvents or petroleum-based cleaners. They should be cleaned with water, a household cleaner and a soft brush. Wash these panels as...

Minor body damage — restoration
Plastic parts (front and rear bumpers) The restoration procedure described below applies only to minor damage and chips on plastic parts. In case of serious damage to...

Restoration of serious body damage
1. Serious damage to the body must be repaired at a service station, since this work requires special equipment. 2. If serious damage has occurred, you must contact a...

Radiator Grille (Mazda 626 model) — replacement
1. Open the hood. 2. Remove the mounting screws from the center and top end of the grille. 3. Using a screwdriver, press the two latches and pull the grill out. 4. When...

Hood — removal, installation and adjustment
Note: The hood is a heavy and awkward part of the car, so we recommend having two people remove and install the hood. Removal and installation 1. Open the hood and cover...

Hood Lock and Cable — removal and installation
Note: The models described in this manual are equipped with an airbag system. Before working in the immediate vicinity of impact sensors, the steering column, or the...

Bumpers — removal and installation
Note: The models described in this manual are equipped with an airbag system. Before working in the immediate vicinity of impact sensors, the steering column, or the...

Front fender — removal and installation
1. Raise the vehicle, support it on supports and remove the front wheel. 2. Remove the front bumper cover ( see paragraph 12 ). 3. Remove the screws to the rep pen and...

Hood fairing — removal and installation
1. Remove the windshield wiper arms (figure 14.1). 2. Depending on the car model, unscrew the screws or remove the fasteners that secure the fairing to the car (figure...

Mirrors — removal and installation
Exterior mirrors 1. On models with electric mirrors, remove the door trim and protective covering ( see paragraph 15 ). 2. Remove the inner trim of the mirror (figure...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections on repairs of other Mazda models
• Body: Exterior (external elements) Mazda6 GG (2002-2008)
• Body: Exterior (external elements) Mazda CX-5KE (2012-2017)
• Body: Exterior (external elements) Mazda 121 (3) (1996-2003)

Share with friends on social networks:

Link in different formats to this section

TEXTHTMLBB Code

Capella 5 (1991-1997)