Electrical equipment of the car engine Mazda 626 (6)

Technical data of engine electrical equipment
Battery voltage With the engine not running - 11.5-12.0 V With the engine running - 13.5-15.0 V Ignition system System type 1993 models - Distributor, coil in control...

General information about engine electrical equipment
The engine electrical system includes the ignition, battery charging and starting systems (figure 1.1, a, b). Because these components are related to engine operation,...

Battery — checking and replacing
Always disconnect the negative battery terminal first and reconnect it last. Otherwise, when loosening the positive terminal, the key may accidentally touch the housing...

Battery Cables — checking and replacing
1. Periodically inspect the battery cables along their entire length for damage, burns or cracks in the insulation, and corrosion of the contacts. Poor battery cable...

Ignition system — basic information
Caution: Since the ignition system contains high voltage, exercise extreme caution when working with it. This applies not only to the booster, coil, distributor and...

Ignition system — check
Caution! Because there is high voltage in the ignition system. please exercise special care when working with it. This applies not only to the booster, coil, distributor...

Ignition coil — checking and replacement
Distributor ignition systems Examination 1. Turn the ignition key to the OFF position. 2. If the ignition coil is located in the distributor, remove the distributor from...

Ignition Control Unit — checking and replacing
Examination 1. The ignition control unit is an electronic switch that breaks the ground circuit of the primary winding of the coil at the right moment, causing a high...

Ignition distributor — removal and installation
Removal 1. Disconnect the negative cable from the battery. Warning. If your vehicle's audio system is equipped with anti-theft protection, make sure you have the unlock...

Charging System — basic information and cautions
The battery charging system consists of: a generator, a voltage regulator built into the generator, a charge indicator light, a fuse, and wires connecting the system...

Charging system — check
1. If a problem occurs in the charging system, do not rush to blame the generator. First, perform the following checks: a) Check the reliability of the fastening of the...

Generator — removal and installation
Removal 1. Disconnect the negative cable from the battery. Warning. If your vehicle's audio system is equipped with anti-theft protection, make sure you have the unlock...

Starting System — basic information and precautions
The starting system consists of an electric starter motor, a traction relay and wires that form an electrical circuit. The traction relay is mounted directly on the...

Starter and its circuit — checking
1. If a malfunction occurs in the starting system, do not assume that the starter is necessarily to blame. Please perform the following checks first. a) Check the...

Starter — removal and installation
1. Disconnect the negative battery cable. Warning. If your vehicle's audio system is equipped with anti-theft protection, make sure you have the unlock code before...

Starter solenoid relay — removal and installation
1. Disconnect the negative battery cable. Warning. If your vehicle's audio system is equipped with anti-theft protection, make sure you have the unlock code before...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections on repairs of other Mazda models
• Power unit: Engine electrical equipment Mazda3 BK (2003-2009)
• Power unit: Electrical equipment of engines Mazda6 GG (2002-2008)
• Power unit: Engine electrical equipment Mazda CX-5KE (2012-2017)
• Power unit: Engine electrical equipment Mazda BT-50 (1) (2006-2011)

Share with friends on social networks:

Link in different formats to this section

TEXTHTMLBB Code

Capella 5 (1991-1997)