All models described in this manual are equipped with a dual-circuit hydraulic braking system with servo assistance. The wheel brakes of all models are disc, some models have rear drum brakes.
Specifications Brake pedal Height (to carpet): – models 1993–1997 of release 156 - 161 mm – 1998 models 175 - 0.5 mm Free move: – Models from 1993-1997: • models with manual...
Anti-lock brake system (ABS) The ABS system consists of two subsystems: electrical and hydraulic. The electrical subsystem includes four wheel sensors and an electronic control unit. The hydraulic...
Brake pads for disc brakes — replacement Warning! Always replace the brake pads on both wheels at the same time. Take precautions when handling brake dust containing asbestos, which is hazardous to health....
Brake caliper — removal and installation Front wheels Removing 1. Remove the front wheel. 2. Disconnect the brake hose from the caliper and cover the end of the hose. 3. Loosen the caliper mounting bolt. 4....
Brake disc — removal and installation Inspection 1. Remove the brake caliper. 2. Inspect the disc surface for scratches or damage. If the scratches are deeper than 0.3 mm, the disc surface must be...
Brake shoes for drum brakes Warning! Always change the brake pads on both wheels at the same time. Take precautions when handling brake dust containing asbestos, which is hazardous to health. Drum...
Wheel cylinder — removal and installation Removing 1. Remove the brake pads and clean the wheel cylinder. 2. Disconnect the brake pipe. 3. Unscrew the fixing bolts and remove the wheel cylinder. Installation...
Master brake cylinder — removal and installation Removing 1. Disconnect the cruise control cable, if necessary. 2. On manual transmission models, disconnect the hydraulic clutch release hose from the brake fluid...
Brake pipes and hoses Approximately every six months, inspect the rubber brake hoses for cracks, leaks, or wear. Replace hoses if necessary. Check the condition of the brake pipes. Inspection...
Bleeding the brake system If the brake pipe was disconnected from the master brake cylinder or air got into it, it is necessary to pump the entire brake system. If the brake hose was only...
Vacuum booster — removal, inspection and installation Checking work 1. Depress the pedal and start the engine. If the pedal drops a little, then the vacuum booster is working. 2. Depress the brake pedal several times with...
Height and free play of the brake pedal Brake Pedal Height Measurement 1. Adjuster for the length of the pusher and free play of the brake pedal 2. Adjusting bolt for brake pedal height Adjustment Brake pedal...
Handbrake adjustment 1. Remove the handbrake lever cover. 2. Raise the handbrake lever one click. 3. Turn the adjusting nut on the balancer clockwise until the rear wheels can be rotated by...
Handbrake cables Replacement 1. On models with rear drum brakes, remove the brake pads. Squeeze the fastening tabs on the cable sheath and pull the cable through the brake shield. On...
Low brake fluid warning light switch Examination 1. Check that the switch opens the circuit when the float is raised and closes the circuit when the float is lowered. 2. Replace the switch if it is...