Car suspension and wheels Mazda 626 (5)

Suspension and steering components
The front suspension is fully independent and uses MacPherson struts. An anti-roll bar is installed on all models. Front suspension and steering components 1. Steering...

Tightening torques, Nm
Front suspension Suspension arm: - internal hinge bolts • front 78 – 105 • rear 93 – 130 – ball joint nut between the suspension arm and the hub bracket 34 – 57...

Front suspension strut — removal, inspection and installation
Removal 1. Remove the wheel. 2. Remove the brake hose from the bracket on the suspension strut. Remove the ABS sensor wire. 3. Loosen the hub bracket mounting nuts and...

Replacing the front suspension strut components
Removal elements 1. Remove the suspension strut. 2. Clamp the suspension strut in a vice. 3. Place the compressors on the spring and compress it. 4. Unscrew the shock...

Front suspension hub bracket
Removal 1. Remove the tappet from the hub mounting nut. 2. Unscrew the hub mounting nut. 3. Raise the vehicle and support it on supports. Remove the wheel. 4. Remove the...

Front wheel hub and bearing
Due to the complexity of removal and installation operations, it is necessary to contact specialists to perform them.

Front suspension stabilizer bar
Removal 1. Remove the front wheels. 2. Remove the cross member from the bottom of the engine compartment. 3. Remove the transmission mounting bracket. 4. Disconnect the...

Front suspension arm — removal and installation
Removal 1. Remove the wheel. 2. Disconnect the stabilizer bar connecting rod from the control arm. 3. Loosen the ball joint bolt and nut. 4. Disconnect the control arm...

Rear suspension strut — removal, inspection and installation
Removal 1. Remove the rear wheel. 2. Remove the brake hose retaining clip (A) and the ABS sensor wire from the strut mounts. Loosen the mounting nuts (B) and remove the...

Rear wheel hub bracket — removal and installation
Removal 1. Remove the rear wheel. 2. Remove the rear wheel hub and bearing. 3. Remove the brake mechanism from the hub bracket. 4. On models with ABS, remove the wheel...

Rear wheel hub and bearing
Removal 1. Remove the wheel. 2. Unscrew the hub mounting nut. 3. Remove the brake drum or disc. 4. Remove the hub and bearing. Installation 5. Installation is carried...

Rear suspension stabilizer bar
Removal 1. Remove the rear wheels. 2. Loosen the mounting nuts and disconnect the connecting rods from the anti-roll bar. 3. Loosen the mounting bolts and remove the...

Rear suspension arm — removal and installation
Removal 1. Remove the rear wheels. Transverse levers Front control arm 2. Loosen and remove the through bolt (indicated by arrows), fastening the levers to the hub...

Tire size
A. Section width B. Section height P 185/ 80 R 13 1. Tire type P – passenger T – spare tire C – commercial 2. Section width (mm) 185 195 205, etc. 3. Ratio (section...

Wheel alignment angles
Wheel alignment, camber angle and kingpin caster angle 1. Wheel alignment 2. Longitudinal inclination of the kingpin 3. Forward 4. Convergence (Y – X)

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections on repairs of other Mazda models
• Chassis: Suspension and wheels Mazda3 BK (2003-2009)
• Chassis: Suspension and wheels Mazda6 GG (2002-2008)

Share with friends on social networks:

Link in different formats to this section

TEXTHTMLBB Code

Capella 5 (1991-1997)