Contents: Removal ⇓ Installation ⇓
Removal
1. Remove the front wheels.
2. Remove the cross member from the bottom of the engine compartment.
3. Remove the transmission mounting bracket.
4. Disconnect the oxygen sensor connector.
5. Disconnect the exhaust pipe from the exhaust manifold.
6. Disconnect the rods from the gearbox.
7. Disconnect the connecting rods from the stabilizer bar.
8. Remove the stabilizer bar fasteners.
9. Place a jack under the front suspension cross member, remove the four mounting bolts and two nuts, and lower the cross member.
10. Remove the anti-roll bar from the vehicle.
11. Check the condition of the mounting bushings and ball joints of the connecting rods. Replace worn parts.
Installation
12. Installation is carried out in the reverse order of removal.