Interlock switch connection connectors
1. 3-pin connection connector
2. 5-pin connection connector
Examination
Check that the switch closes the circuit when the clutch pedal is pressed. In this case, there should be conductivity between terminals 1 and 2 of the connection connector. When the pedal is released, the switch should open the circuit. Adjust or replace the switch if necessary.
Replacement
1. Disconnect the switch connection connector. Next, depending on the model, rotate the switch 90° and remove it from the mounting bracket, or unscrew the two mounting screws and remove the switch.
2. Installation is carried out in the reverse order of removal.
Adjustment
Loosen the mounting nuts and change the position of the switch as needed. Tighten the mounting nuts.