Replacing tie rod ends (Mazda CX-5KE)

1. Remove the cotter pin from the tie rod end nut.



2. Loosen the tie rod end nut.

3. Using a special puller, disconnect the steering rod end from the steering knuckle.



4. Completely unscrew the tie rod end nut.

5. Apply alignment marks as shown in the figure for correct installation later.



6. Remove the tie rod end.





7. Align the alignment marks made before removing the tie rod end, then install the tie rod end in place and tighten the lock nut to the specified tightening torque.



8. If there are no alignment marks, adjust dimension A shown in the figure to the standard value (10.1-23.1 mm).



9. Install the steering rod end onto the steering knuckle.



10. Tighten the nut to the specified tightening torque and insert a new cotter pin.

Note: replace the part with a new one after each removal.

11. After installation, check the wheel alignment angles (see chapter "Suspension"). Adjust if necessary.