Contents: Removal ⇓ Installation ⇓
Removal
Mark the position of the front wheels on the hubs so that you can then install the balanced wheel in its original position. Loosen the wheel nuts with the car on the ground. Raise and support the car from the front and remove the front wheels.
Unscrew the two screws (arrows) on each side.
Remove the front license plate.
Unscrew the three bolts (arrows).
Unscrew the three screws on top of the radiator grille.
Unhook four clips (arrows) on each side.
Unscrew the bumper fasteners from the body and remove it from the front with the help of an assistant.
Installation
Place the bumper with an assistant and secure it to the body.
Attach the bumper to the side and secure with bolts at the front.
Screw in two screws into the wheel arches.
Install front license plate.
Install the front wheels according to the marks made earlier. Before doing this, lubricate the central hole of the disk with consistent grease. Do not lubricate the threads of the wheel studs. Tighten the wheel nuts. Lower the car and tighten the wheel nuts crosswise to a torque of 90 Nm.