Contents: Removal ⇓ Installation ⇓
Removal
Remove the front bumper.
Remove the inner part of the wing.
Remove the side turn signal.
Carefully pull the wing, section by section.
Installation
Clean the wing mating surfaces and level them if necessary.
Touch up the wing if necessary.
Places for the wing to fit on the wheel well and the front pillar (the pillar to which the front door is attached) coat with zinc primer to protect against corrosion.
Apply suitable sealing tape to the wing attachment points.
Install the wing, align it and secure it with bolts. At the same time, ensure an even gap between the wing and the hood, as well as the door.
Attention: The fastening bolts (self-tapping screws) must be tightened lightly, i.e. with a torque of 5 Nm.
Install bottom protection on the inner side of the wing.
Install the side turn signal.
Install the inner wing part.
Install the bumper.