Intermediate drive shaft assembly.
1 - body,
2 - oil seal,
3 - adjusting washer,
4 - bearing,
5 - intermediate drive shaft,
6 - bearing,
7 - retaining ring,
8 - spacer,
9 - hub of the front axle disconnect mechanism,
10 - retaining ring,
11 - anther,
12 - needle bearing,
13 - retaining ring,
14 - front axle disconnect mechanism.
Assembly Notes
1. Measure the clearance between the retaining ring and the bearing. If necessary, adjust the clearance by selecting the thickness of the adjusting washers.
[The article is based on website data: MAZBOOK]
- The maximum allowable gap is 0.15 mm
Note:
- do not install more than two adjusting washers;
- adjusting washers are available in 0.15 thickness; 0,30; 0,35; 0,40; 0.50 mm.
2. Measure the clearance between the retaining ring and the hub of the front axle release mechanism. If necessary, adjust the clearance by selecting the thickness of the adjusting washers.
- The maximum allowable gap is 0.15 mm
Note:
- do not install more than two adjusting washers;
- adjusting washers are available in 0.15 thickness; 0,30; 0,35; 0,40; 0.50 mm.
