Checking the one-way valve (Mazda BT-50 (1))

1. Remove the one-way valve.

2. Apply compressed air to the "A" side of the hose and make sure that air comes out of the "B" side.

3. Apply compressed air from side "B" and make sure that no air comes out from side "A".

Replace the one-way valve if necessary.

The primary source is the website www.MAZbook.ru

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This text was checked by: Vladimir Bazhenov

Share with friends on social networks:

Mazda BT-50 (1) » All-wheel drive system

Front axle switch
Checking the front axle disconnect sensor
Checking the transfer case neutral gear engagement sensor
Checking the all-wheel drive engagement sensor
All-wheel drive system — device

Checking the electromagnetic valves for connecting and disconnecting…
Checking the front axle disconnect drive
Intermediate Drive Shaft Assembly — Removal and Installation
Intermediate Drive Shaft Assembly — Disassembly and Assembly
Front Axle Disconnection Mechanism — Removal and Installation

More articles on repairing other Mazda models
Checking the tire valve Mazda Familia 6 (1989-1994)
Checking the Exhaust Gas Recirculation (EGR) Valve Mazda Capella 3 and 4 (1982-1992)
Checking the Oil Control Valve (OCV)(L3) Mazda3 BK (2003-2009)
Checking the Oil Control Valve (OCV) (L3) Mazda6 GG (2002-2008)
Checking the electric valve timing motor Mazda CX-5KE (2012-2017)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet