Removal and installation the high beam lamp (Mazda 6 GG)

Disconnect the negative cable from the battery.

Fig. 7.28. Procedure for removing high beam lamp components: 1 – lid; 2 – connector; 3 – high beam lamp

Remove in the order shown in Figure 7.28.

To remove the lamp, release the spring latch.

Install in the reverse order of removal.

(The text of the article is taken from the website: MAZBOOK.ru)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This text was checked by: Evdokia Filimonova

Share with friends on social networks:

Mazda6 GG » Lighting system

Removal and installation a gas discharge lamp headlight
Removal and installation the headlight bulb
Adjusting the high beam headlights
Adjusting the low beam headlights
Removal and installation the front combination headlight

Removal and installation the parking light bulb
Removal and installation the front turn signal
Removal and installation the side turn signal
Adjusting the front fog light
Removal and installation the front fog light bulb

More articles on repairing other Mazda models
J. Wiring diagram for the lamps in the door pillars, the ignition… Mazda Familia 5 (1985-1989)
Indicator lamp symbols Mazda Capella 3 (1982-1992, petrol)
High-low beam headlight switching modes Mazda3 BK (2003-2009)
High beam control system (HBC) Mazda CX-5KE (2012-2017)
Checking high voltage wires Mazda 121 (3) (1996-2003)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Mazda6 GG (2002-2008)