Front part
Disconnect the negative cable from the battery.
Fig. 7.47. Procedure for removing door limit switch components: 1 – screw; 2 – door switch; 3 – connector
Remove in the order shown in Figure 7.47.
Install in the reverse order of removal.
Rear end
Disconnect the negative cable from the battery.
Fig. 7.48. Procedure for removing door limit switch components: 1 – screw; 2 – door switch; 3 – connector
Remove in the order shown in Figure 7.48.
Install in the reverse order of removal.
Checking the door limit switch
Remove the door limit switch.
Fig. 7.49. Door limit switch test diagram
Check the integrity of the circuit between the door switch terminal and the base of the housing using an ohmmeter (Fig. 7.49).
Article is available on the website Mazbook.ru
If the measurements do not match the data given in the table, replace the limit switch.