Disconnect the negative battery cable.
Remove the bottom protective cover.
Drain the engine oil.
Remove the front engine cover.
Fig. 2.205. Removing the oil pan: 1 – oil dipstick; 2 – oil pan
Remove the dipstick tube and oil pan (fig. 2.205).
Fig. 2.206. Aligning the oil pan with the cylinder block
Use a square to align the oil pan with the cylinder block on the front engine cover side (fig. 2.206).
Fig. 2.207. Applying sealant before installing the oil pan
Apply silicone sealant to the mating surface of the oil pan as shown in Figure 2.207.
Fig. 2.208. Oil pan mounting bolt tightening sequence
The original article is available on mazbook
Tighten the pan mounting bolts in the order shown in Figure 2.208.
Check the oil level.
Start the engine and check for oil leaks. If there is a leak, identify the defective part, repair or replace it.