Car doors and windows Mazda 3 (BK)

Front and rear door components
The interior structure of the door includes: power window regulator, interior handle, door speaker, harness and interior partitions. The wave-shaped side impact bar is...

Removal and installation the front door
Disconnect the negative cable from the battery. To remove the door opening limiter, remove the following items: interior decoration; window lift handle (cars with manual...

Removal and installation the rear door
Caution: Improper handling of the side airbag sensor may result in accidental airbag deployment, which could result in serious injury. Note: The side airbag sensor is...

Door adjustment
Fig. 8.22. Door adjustment diagram Measure the gap and height difference between the front or rear door and the body (Fig. 8.22). Loosen the door hinge mounting bolts or...

Tailgate adjustment
Fig. 8.23. Tailgate adjustment diagram Measure the gap and height difference between the tailgate and the body (Fig. 8.23). Loosen the tailgate hinge mounting nuts and...

Removal and installation front door glass
Fig. 8.24. Installing glass before removing Install the front door glass so that the distance from the top of the front door glass to the window trim is 210 mm (Fig....

Removal and installation rear door glass
Roll down the rear door glass completely. Remove the rear door trim. Remove the plug. Pull the rear door seal tight and remove the screw. Loosen the bolt. Fig. 8.26....

Removal and installation the front door unit
Remove the front door glass. Remove the inner handle. Remove the front door speaker. Disconnect the power window motor connector, front door lock actuator connector,...

Removal and installation the rear door unit
Remove the rear door glass. Remove the inner handle. Remove the rear door speaker. Disconnect the power window motor connector and the automatic door lock actuator...

Main characteristics of window lifters
Based on the pulse signals from the proximity switches on the Hall sensor in the power window motor, the power window control module in its main switch determines the...

Electric window lift motor with servo drive
Design and operating principle. The power window motor is equipped with a connector and a gear. Two proximity switches on the Hall sensor are mounted in the connector....

Door lock servo system
Fig. 8.33. Wiring diagram of the remote door lock control system: 1 – Engine compartment light; 2 – trunk lid lock switch; 3 – Front door lock switch (left); 4 – Front...

Removal and installation a power window regulator
Disconnect the negative battery cable. Remove the front door/rear door glass. Remove the front door/rear door speaker. Remove the power window motor. Fig. 8.34....

Removal and installation the window lift motor with servo drive
Disconnect the negative battery cable. Remove the front door trim or rear door trim. Disconnect the power window motor connector. Loosen the bolts. Fig. 8.37. Removing...

Removal the windshield
Disconnect the negative cable from the battery. Remove the following items: windshield wiper arm with brush; front shield grille; rear view mirror; rain sensor (Cars...

Windshield installation
Warning! The windshield may not be installed correctly if the seal is damaged or the glass is pushed out by air pressure when opening and closing the doors with the...

Outside rear view mirrors
The driver's mirror provides a wide field of view and consists of two zones (external and internal) with different curvature of the reflective surface. The outer and...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections on repairs of other Mazda models
• Body: Doors and windows Mazda Familia 6 (1989-1994)
• Body: Doors, windows and locks Mazda Capella 6 (1997-2005, petrol)
• Body: Doors and windows Mazda6 GG (2002-2008)
• Body: Doors, windows and locks Mazda 121 (3) (1996-2003)

Share with friends on social networks:

Link in different formats to this section

TEXTHTMLBB Code

Mazda3 BK (2003-2009)