Remove the rack cover clamp.
Rotate the tie rod to adjust the steering angle.
Note. The stroke of the right and left tie rods must be the same.
Pic. 4.2. Tie Rod Rotation
By rotating the steering rod, ensure that the difference between the dimension L shown in the figure, on the right and on the left, is less than normal (pic. 4.2).
Standard: 3 mm or less.
Tighten the tie rod end locknut.
Tightening torque: 68.6 - 98.0 Nm.
Eliminate the twisting of the rack cover.
Install and secure the rail cover clamp.
After adjusting the steering angle, always check and adjust the toe angle.