Fig. 3.119. Knocking out the flange of the wheel hub lock nut
Knock out the bent part of the lock nut with a small chisel and hammer (fig. 3.119).
Lock the hub by pressing the brake.
Loosen the lock nut.
Attention! The rotor of the anti-lock brake system sensor is removed only in case of its replacement.
Fig. 3.120. Removing the ABS sensor rotor
Using a chisel, remove the ABS sensor rotor (fig. 3.120).
Fig. 3.121. Correct installation of the ABS sensor rotor: 1 – wheel hub; 2 – ABS sensor rotor
To install the ABS sensor rotor, orient the special tool so that the B marking faces downwards (fig. 3.121).
Fig. 3.122. Pressing in the ABS sensor rotor
(The original text can be found on: «MAZbook.ru»)
Press in the new sensor rotor using a special tool and press (fig. 3.122).
Fig. 3.123. Installing a new lock nut
Install a new lock nut and secure it as shown in Figure 3.123.