Contents: Removal ⇓ Installation ⇓
Fig. 4.35. Rear coil spring: 1 – bolt (lower part of the stabilizer strut); 2 – bolt (rear lower control arm, outer side); 3 – rear coil spring; 4 – upper spring cup gasket; 5 – lower spring cup; 6 – compression stroke buffer (from the spring side); 7 – compression stroke buffer (from the body side)
The rear coil spring is shown in Fig. 4.35.
Removal
Remove the rear auto leveling sensor.
Fig. 4.36. Installing a jack under the lower arm
Support the lower arm with a jack (Fig. 4.36).
Loosen the lower control arm inner bolt.
Remove the lower control arm outer bolt.
Using an adapter, remove the compression stroke buffer (from the body side).
Installation
Fig. 4.37. Installing a coil spring
Install the coil spring so that the mark is located at the bottom (Fig. 4.37).
Place a jack under the lower control arm and slowly lift the arm.
Warning! Installing a coil spring is dangerous and may cause the spring to fly out and cause serious injury or death.