2. Raise the hood and determine the location of the lamps installed in the high and low beam headlights from the back of the headlamp housing.
The lamp located at the edge belongs to the dipped beam headlight, and the lamp located closer to the center of the car belongs to the high beam headlight.
Pic. 1.193. Disconnecting the electrical connector
3. Disconnect the electrical connector (pic. 1.193).
4. Raise the air cleaner housing.
5. Press the release tab located on top of the seal cap and remove the cap.
6. Disconnect the electrical connector from the lamp by pulling it back.
Pic. 1.194. Removing the Spring Lamp Holder
7. Unfasten the spring lamp holder (pic. 1.194).
8. Pull the spring holder up to release the lamp.
9. Carefully remove the lamp from its socket by pulling it back.
10. Replace lamp.
11. Reinstall all parts by following the above steps in reverse order.
Note. After reinstalling the air cleaner housing, check the connection of the electrical connector.
Note. After connecting the electrical connector, insert the electrical harness into the holder located on the side of the air cleaner housing.
Note. Pack the burned out lamp in the new lamp box. Dispose of overheated lamps out of the reach of children.